Frictional properties of natural fault gouge from a low‐angle normal fault, Panamint Valley, California
Authors:
- 16 March 2007
- journal article
- Published by American Geophysical Union (AGU) in Tectonics
- Vol. 26 (2)
Abstract
We investigate the relationship between frictional strength and clay mineralogy of natural fault gouge from a low‐angle normal fault in Panamint Valley, California. Gouge samples were collected from the fault zone at five locations along a north–south transect of the range‐bounding fault system, spanning a variety of bedrock lithologies. Samples were powdered and sheared in the double‐direct shear configuration at room temperature and humidity. The coefficient of friction, μ, was measured at a range of normal stresses from 5 to 150 MPa for all samples. Our results reinforce the intuitive understanding that natural fault gouge zones are inherently heterogeneous. Samples from a single location exhibit dramatic differences in behavior, yet all three were collected within a meter of the fault core. For most of the samples, friction varies from μ = 0.6 to μ = 0.7, consistent with Byerlee's law. However, samples with greater than 50 wt % total clay content were much weaker (μ = 0.2–0.4). Expandable clay content of the samples ranged from 10 to 40 wt %. Frictional weakness did not correlate with expandable clays. Our results indicate that friction decreases with increasing total clay content, rather than with the abundance of expandable clays. The combination of field relations, analytical results, and friction measurements indicates a positive correlation between clay content, fabric intensity, and localization of strain in the fault core. A mechanism based upon foliations enveloping angular elements to reduce friction is suggested for weakening of fault gouge composed of mixed clay and granular material. We provide broad constraints of 1–5 km on the depth of gouge generation and the depth at which fault weakness initiates. We show that slip on the Panamint Valley fault and similar low‐angle normal faults is mechanically feasible in the mid‐upper crust if the strength of the fault is limited by weak, clay‐rich fault gouge.Keywords
This publication has 59 references indexed in Scilit:
- The development and behaviour of low-angle normal faults during Cenozoic asymmetric extension in the Northern Apennines, ItalyJournal of Structural Geology, 2006
- Influence of grain characteristics on the friction of granular shear zonesJournal of Geophysical Research, 2002
- Experimental investigation into the microstructural and mechanical evolution of phyllosilicate-bearing fault rock under conditions favouring pressure solutionJournal of Structural Geology, 2001
- Laboratory results indicating complex and potentially unstable frictional behavior of smectite clayGeophysical Research Letters, 2001
- Clay gougeJournal of Structural Geology, 1999
- The mechanical feasibility of low-angle normal faultingTectonophysics, 1999
- Origin of regional, rooted low‐angle normal faults: A mechanical model and its tectonic implicationsTectonics, 1989
- Normal faulting in the upper continental crust: observations from regions of active extensionJournal of Structural Geology, 1989
- Frictional dependence of gouge mixtures of quartz and montmorillonite on velocity, composition and fabricTectonophysics, 1987
- Composite planar fabric of gouge from the Punchbowl Fault, CaliforniaJournal of Structural Geology, 1987