The Use of Methanol Vapour for Effective Drying of Cellulose Insulation
Open Access
Abstract
The paper deals with a new method of drying cellulose insulation, which uses methanol vapour present in nitrogen as a drying medium. Compared to the insulation drying methods currently used in the industry, the method presented in the article has the following advantages: there is no cellulose depolymerization because there is no need to heat the insulation, there is no need to use large-size and energy-intensive dryers because the whole process takes place in the tank of the transformer. Important parameters of the drying process, such as methanol concentration in the nitrogen, flow rate, and process duration, were determined in four separate experiments. For the purposes of these experiments, a special system was constructed to control and measure the flow of drying medium. Controlling the flow rate of the carrier gas (nitrogen) made it possible to obtain different concentrations of methanol in nitrogen. Such values of concentration and flow rate were determined that allow drying of pressboard and paper in less than 144 h to a level lower than 1%.Keywords
Funding Information
- Politechnika Poznańska (0711/SBAD/4560)
This publication has 18 references indexed in Scilit:
- A new method for indirect measurement of water content in fibrous electro-insulating materials using near-infrared spectroscopyIEEE Transactions on Dielectrics and Electrical Insulation, 2016
- Review of Physicochemical-Based Diagnostic Techniques for Assessing Insulation Condition in Aged TransformersEnergies, 2016
- Effect of hydrogen bonding on self-diffusion in methanol/water liquid mixtures: A molecular dynamics simulation studyJournal of Molecular Liquids, 2015
- Ageing of thermally and electrically stressed mineral oil impregnated presspaper insulation systems2014
- Water Absorption of Cellulosic Insulating Materials used in Power Transformers2007
- Aging of cellulose at transformer service temperatures. Part 1: Influence of type of oil and air on the degree of polymerization of pressboard, dissolved gases, and furanic compounds in oilIEEE Electrical Insulation Magazine, 2005
- Aging of Oil-Impregnated Paper in Power TransformersIEEE Transactions on Power Delivery, 2004
- Degradation of cellulosic insulationin power transformers.Part 1: Factors affecting the measurement of the average viscometric degree ofpolymerisation of new and aged electrical papersIEE Proceedings - Science, Measurement and Technology, 2000
- Aging of insulation by thermal and electrical stresses1975
- Basic laws of the vacuum drying process applied to cellulose materials for electrical insulationJournal of Engineering Physics and Thermophysics, 1972