The effect of in-plane layer orientation on mixed-mode I-II fracture behavior of 3D-printed poly-carbonate specimens
Authors:
- Bahador BahramiBBBahador Bahrami
- Majid R. AyatollahiMAMajid R. Ayatollahi
- Iman SedighiISIman Sedighi
- Marco A. PérezMPMarco A. Pérez
- Andrés A. Garcia-GranadaAGAndrés A. Garcia-Granada
- 1 May 2020
- journal article
- research article
- Published by Elsevier in Engineering Fracture Mechanics
- Vol. 231
Abstract
No abstract availableKeywords
This publication has 39 references indexed in Scilit:
- Fracture resistance measurement of fused deposition modeling 3D printed polymersPolymer Testing, 2017
- Characterization of stiffness degradation caused by fatigue damage of additive manufactured partsMaterials & Design, 2016
- On the necessity of using critical distance model in mixed mode brittle fracture prediction of V-notched Brazilian disk specimens under negative mode І conditionsTheoretical and Applied Fracture Mechanics, 2016
- Mixed mode I/II brittle fracture in V-notched Brazilian disk specimens under negative mode I conditionsPhysical Mesomechanics, 2016
- Impact absorption capacity of 3D-printed components fabricated by fused deposition modellingMaterials & Design, 2016
- An approach for mechanical property optimization of fused deposition modeling with polylactic acid via design of experimentsRapid Prototyping Journal, 2016
- Influence of Layer Thickness and Raster Angle on the Mechanical Properties of 3D-Printed PEEK and a Comparative Mechanical Study between PEEK and ABSMaterials, 2015
- Deposition direction-dependent failure criteria for fused deposition modeling polycarbonateRapid Prototyping Journal, 2014
- Wide range data for crack tip parameters in two disc-type specimens under mixed mode loadingComputational Materials Science, 2007
- Mixed mode brittle fracture in PMMA—An experimental study using SCB specimensMaterials Science and Engineering: A, 2006