Design Considerations of Sight Distance Red Zones on Crest Curves
Authors:
- 1 July 1998
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Transportation Engineering
- Vol. 124 (4) , 343-352
Abstract
The American Association of State Highway and Transportation Officials (AASHTO) presents general controls for the combination of horizontal and vertical alignments. Excellence in alignment coordination enhances safety, operation, and appearance. This paper quantifies one of the AASHTO general controls that is related to introducing a horizontal curve at or near the top of a crest vertical curve. It establishes the locations where a horizontal curve should not start in relation to a vertical curve because the available sight distance is less than (1) the stopping-sight distance (SSD); or (2) the preview sight distance (PVSD) that allows the driver to detect the horizontal curve and react properly and comfortably. The range of these locations, called the “red zone,” is established for a selected alignment using three-dimensional (3D) analysis of sight distance. Both daytime and nighttime cases are discussed. The sensitivity of the red zones for PVSD to the superelevation rate, turning direction of horizonta...Keywords
This publication has 7 references indexed in Scilit:
- Design of Sag Vertical Curves in Three-Dimensional AlignmentsJournal of Transportation Engineering, 1998
- Design Considerations for Combined Highway AlignmentsJournal of Transportation Engineering, 1997
- Automation of determining passing and no-passing zones on two-lane highwaysCanadian Journal of Civil Engineering, 1997
- Modeling Headlight Sight Distance on Three-Dimensional Highway AlignmentsTransportation Research Record: Journal of the Transportation Research Board, 1997
- Sight distance evaluation on complex highway vertical alignmentsCanadian Journal of Civil Engineering, 1996
- Analytical Model for Sight Distance Analysis on Three-Dimensional Highway AlignmentsTransportation Research Record: Journal of the Transportation Research Board, 1996
- Design considerations for highway sight-hidden dipsTransportation Research Part A: Policy and Practice, 1994