Effects of Cr Content on Microstructure and Mechanical Properties of Co-Free FeCryNiAl0.8 High-Entropy Alloys
Open Access
Abstract
High-entropy alloys have gained widespread concern in response to the increased requirements for future high-temperature structural superalloys. By combining phase-diagram calculations with microhardness, compression behavior measurements at room temperature, and elevated temperature conditions, the very important role of the Cr element on the microstructure and properties is deeply revealed, which provides candidates materials for future high-temperature alloy applications. The increment of Cr favors the regulation of the two-phase fraction and distribution. The thermodynamic calculations illustrate that the density and melting point of the HEAs showed an increasing trend with the increase of the Cr content. The typical worm-like microstructure of the Cr0.6 alloy with a dual BCC structure was detected. Meanwhile, on the one hand, the increment of the Cr elements results in a considerable optimization of the mechanical properties of the alloy in terms of strength and ductility at room temperature. The corresponding compressive strength and plasticity of Cr0.6 alloy at room temperature are 3524 MPa and 43.3%. On the other hand, the high-temperature mechanical properties of the alloy are greatly enhanced. At 1000 °C, the yield strength of the Cr0.6 alloy is about 25 MPa higher than that of the Cr0.4 alloy. The superior mechanical properties are attributed to the pronounced work-hardening response, and the work-hardening behavior of Cr-containing HEAs was systematically analyzed by employing the modified Ludwik model. The higher content of Cr helps the resistance of the local deformation response, improving the nonuniform strain and promoting the balance of strength and ductility of the alloys.Keywords
This publication has 58 references indexed in Scilit:
- Enhanced strength and ductility of bulk CoCrFeMnNi high entropy alloy having fully recrystallized ultrafine-grained structureMaterials & Design, 2017
- Directly cast bulk eutectic and near-eutectic high entropy alloys with balanced strength and ductility in a wide temperature rangeActa Materialia, 2017
- Effects of aluminum on microstructure and compressive properties of Al-Cr-Fe-Ni eutectic multi-component alloysMaterials Science and Engineering: A, 2017
- Stability of ordered L12 and B2 precipitates in face centered cubic based high entropy alloys - Al0.3CoFeCrNi and Al0.3CuFeCrNi2Scripta Materialia, 2016
- On the superior hot hardness and softening resistance of AlCoCrxFeMo0.5Ni high-entropy alloysMaterials Science and Engineering: A, 2011
- Microstructural development in equiatomic multicomponent alloysMaterials Science and Engineering: A, 2004
- Nanostructured High‐Entropy Alloys with Multiple Principal Elements: Novel Alloy Design Concepts and OutcomesAdvanced Engineering Materials, 2004
- Constitutive behavior of as-cast AA1050, AA3104, and AA5182Metallurgical and Materials Transactions A, 2002
- Mathematical description for flow curves of some stable austenitic steelsMaterials Science and Engineering: A, 1994
- Limitations of the Hollomon strain-hardening equationJournal of Physics D: Applied Physics, 1974