Design considerations for single-stage electronic ballast with dimming feature
Authors:
- Tsai-Fu WuTWTsai-Fu Wu
- Yung-Chun WuYWYung-Chun Wu
- Zing-Ying SuZSZing-Ying Su
- 1 January 2001
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industry Applications
- Vol. 37 (5) , 1537-1543
Abstract
Design considerations for single-stage electronic ballast with a dimming feature are presented in this paper. When the lamps are dimmed out to a lower light level, the density of electrons will drop significantly, which would result in visible striation. Moreover, power imbalance exists between the power factor correction semistage and the ballast semistage, which usually results in a high DC-link voltage and might damage the switching devices. Strategies for suppressing the high DC-link voltage and eliminating the effect of striations occurring in a fluorescent lamp are therefore proposed. In addition, an improvement on the jump phenomenon of lamp luminous output when it is controlled by varying the switching frequency is also proposed. Hardware measurements have been presented to verify the theoretical discussions.Keywords
This publication has 23 references indexed in Scilit:
- Design considerations for optimum ignition and dimming of fluorescent lamps using a resonant inverter operating open loop2002
- A new control method for dimmable high-frequency electronic ballasts2002
- Pulsewidth modulation control of electronic ballast for dimming control of fluorescent lamps2002
- Charge pump high power factor dimming electronic ballast2002
- Design and analysis of dimming electronic ballast2002
- A fluorescent lamp model for high frequency wide range dimming electronic ballast simulation1999
- Designing dimmable electronic ballast with frequency control1999
- A new control IC for dimmable high-frequency electronic ballasts1999
- Off-line applications with single-stage convertersIEEE Transactions on Industrial Electronics, 1997
- Development of an Electronic Dimming Ballast for Fluorescent LampsJournal of the Illuminating Engineering Society, 1992