A simple frequency response compensation method for current probe measurements of ESD currents
- 1 August 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 158-163
Abstract
The transfer impedance of a current probe is typically not constant within the current probe's operational frequency range. As it is based on induction, it will suffer from reduced sensitivity at lower frequencies. Thus, a current probe cannot be used directly in a time domain measurement. The low frequency roll-off of a current probe can severely distort the actual waveform. A simple frequency response compensation method is proposed here to enable ESD current measurements with current probes. The method enables a current probe to be used for time domain measurements, such as when measuring ESD transient current and estimating the total transferred charge. If a probe's datasheet provides the transfer impedance for the probe, no additional measurements are needed. Advantages and disadvantages of directly using the measured complex transfer impedance, instead of approximating the transfer impedance by a circuit, is discussed in this paper.Keywords
This publication has 7 references indexed in Scilit:
- Wide band measurements in time domain with current and voltage probes for power losses evaluation and EMC measurements on power converters2015
- Time Lag of Secondary ESD in Millimeter-Size Spark GapsIEEE Transactions on Electromagnetic Compatibility, 2014
- Proposal for Measurement Method of Transfer Impedance of Current ProbeIEEE Transactions on Electromagnetic Compatibility, 2014
- Model of Secondary ESD for a Portable Electronic ProductIEEE Transactions on Electromagnetic Compatibility, 2012
- A New Test Setup and Method for the Calibration of Current ClampsIEEE Transactions on Electromagnetic Compatibility, 2005
- Wide-band characterization of current probesIEEE Transactions on Electromagnetic Compatibility, 2003
- Current probes, more useful than you think2002