5.2 Capacitance-to-Digital Converter for Operation Under Uncertain Harvested Voltage down to 0.3V with No Trimming, Reference and Voltage Regulation
Authors:
- 13 February 2021
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 64, 74-76
Abstract
In low-cost battery-less systems, capacitive sensing via capacitance-to-digital conversion (CDC) needs to operate with minimal or no support from additional circuitry such as voltage regulation, voltage/current references or digital post-processing as shown in Fig. 5.2.1 (e.g., for linearization). At the same time, direct harvesting demands operation down to very low voltages and power, to consistently fit the power available from the environment even when scarce (e.g., down to ~nW/mm 2 in light harvesters under realistic conditions). To enable continuous monitoring at power lower than the μW-range of state-of-the-art ~12-bit CDCs [1-3], 7-to-8-bit architectures with power down to sub-nW have been demonstrated for sensor nodes [4], although their supply voltage requirement (≥0.6V) is not suitable for direct harvesting, similar to [5]. CDCs for continuous monitoring at lower resolution (~7 bit) with sub-nW operation at 0.6V have been also demonstrated [6], although their power is burdened by the additional contribution of digital post-processing (~nWs) and others. A fully digital CDC has been introduced in [7] in the form of capacitance-to-voltage conversion via capacitor linear discharge due to a ring oscillator and final voltage-to-digital conversion, which requires two supply voltages of 0.45V and 1V. Operation at minimal power also comes with measurement times in the sub-second or second scale [6,8] in addition to the reduced resolution, which are still in the range required by continuous monitoring in several applications [6,8] (e.g., temperature, humidity, proximity, fluid level monitoring).Keywords
Funding Information
- Ministry of Education
This publication has 7 references indexed in Scilit:
- An 8.2-$\mu$ W 0.14-mm2 16-Channel CDMA-Like Capacitance-to-Digital ConverterIEEE Journal of Solid-State Circuits, 2019
- A 2.92-$\mu$ W Capacitance-to-Digital Converter With Differential Bondwire Accelerometer, On-Chip Air Pressure, and Humidity Sensor in 0.18-$\mu$ m CMOSIEEE Journal of Solid-State Circuits, 2019
- 18.2 A 16fJ/Conversion-Step Time-Domain Two-Step Capacitance-to-Digital Converter2019
- A 595pW 14pJ/Cycle microcontroller with dual-mode standard cells and self-startup for battery-indifferent distributed sensing2018
- A compact sensor readout circuit with combined temperature, capacitance and voltage sensing functionality2017
- An Energy-Efficient Hybrid SAR-VCO $\Delta \Sigma $ Capacitance-to-Digital Converter in 40-nm CMOSIEEE Journal of Solid-State Circuits, 2017
- 27.6 A 0.7pF-to-10nF fully digital capacitance-to-digital converter using iterative delay-chain discharge2015