The Metallurgy of Homogenisation
Author:
- 1 July 2011
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 693, 264-275
Abstract
Homogenisation of aluminium alloys is the high temperature heat treatment (450-600 °C) performed after casting and consists of three distinct steps; heat-up, soak and cooldown. This review considers the metallurgical importance of homogenisation and how it impacts on the further processing and final properties of some aluminium alloys, with emphasis on homogenisation of extrusion billet. The introduction of continuous homogenisation has significantly improved the temperature uniformity of homogenisation allowing the soak time to be minimised. Batch homogenisation, however, provides flexibility in practices tailored for different aluminium alloys. Soft 6060 and 6063 alloys are best homogenised at a higher soak temperature than harder alloys such as 6061 and 6082. The homogenisation cooling rate can also impact on the behaviour of the billet during extrusion processing as well as affecting the final mechanical properties. An understanding of the microstructural changes occurring as a result of homogenisation allows the cast house to ensure that the billet processing meets the customer requirements.Keywords
This publication has 12 references indexed in Scilit:
- Modelling of microsegregation and homogenization of 6061 extrudable Al-alloyJournal of Materials Processing Technology, 2007
- Effect of Changing Homogenization Treatment on the Particle Structure in Mn-Containing Aluminium AlloysMaterials Science Forum, 2007
- Characterisation of AlFeSi Intermetallics in 6000 Series Aluminium Alloy ExtrusionsMaterials Science Forum, 2006
- Effects of homogenisation treatment on microstructure and hot ductility of aluminium alloy 6063Materials Science and Technology, 2005
- The effect of homogenization practice on the microstructure of AA6063 billetsJournal of Materials Processing Technology, 2004
- Assessment of different techniques for quantification of α-Al(FeMn)Si and β-AlFeSi intermetallics in AA 6xxx alloysMaterials Characterization, 2002
- Quantification of the evolution of the 3D intermetallic structure in a 6005A aluminium alloy during a homogenisation treatmentMaterials Characterization, 2002
- Precipitation of dispersoids containing Mn and/or Cr in Al–Mg–Si alloysMaterials Science and Engineering: A, 2000
- Effect of casting and homogenizing treatment conditions on the formation of Al–Fe–Si intermetallic compounds in 6063 Al–Mg–Si alloysJournal of Materials Science, 1999
- Microstructure control and extrudability of Al–Mg–Si alloys microalloyed with manganeseMaterials Science and Technology, 1994