Directional Self-Cleaning Superoleophobic Surface
Authors:
- 30 July 2012
- journal article
- research article
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 28 (32) , 11812-11818
Abstract
In this work, we report the creation of a grooved surface comprising 3 μm grooves (height ∼4 μm) separated by 3 μm from each other on a silicon wafer by photolithography. The grooved surface was then modified chemically with a fluorosilane layer (FOTS). The surface property was studied by both static and dynamic contact angle measurements using water, hexadecane, and a polyethylene wax ink as the probing liquids. Results show that the grooved surface is both superhydrophobic and superoleophobic. Its observed contact angles agree well with the calculated Cassie–Baxter angles. More importantly, we are able to make a replica of the composite wax ink–air interface and study it by SEM. Microscopy results not only show that the droplet of the wax ink “sits” on air in the composite interface but also further reveal that the ink drop actually pins underneath the re-entrant structure in the side wall of the grooved structure. Contact angle measurement results indicate that wetting on the grooved surface is anisotropic. Although liquid drops are found to have lower static and advancing contact angles in the parallel direction, the drops are found to be more mobile, showing smaller hysteresis and lower sliding angles (as compared to the FOTS wafer surface and a comparable 3-μm-diameter pillar array FOTS surface). The enhanced mobility is attributable to the lowering of the resistance against an advancing liquid because 50% of the advancing area is made of a solid strip where the liquid likes to wet. This also implies that the contact line for advancing is no longer smooth but rather is ragged, having the solid strip area leading the wetting and the air strip area trailing behind. This interpretation is supported by imaging the geometry of the contact lines using molten ink drops recovered from the sliding angle experiments in both the parallel and orthogonal directions. Because the grooved surface is mechanically stronger against mechanical abrasion, the self-cleaning effect exhibited in the parallel direction suggests that groove texturing is a viable approach to create mechanically robust, self-cleaning, superoleophobic surfaces.Keywords
This publication has 25 references indexed in Scilit:
- Bioinspired Directional Surfaces for Adhesion, Wetting, and TransportAdvanced Functional Materials, 2012
- Study of Wetting and Adhesion Interactions between Water and Various Polymer and Superhydrophobic SurfacesThe Journal of Physical Chemistry C, 2011
- Fabrication, Surface Properties, and Origin of Superoleophobicity for a Model Textured SurfaceLangmuir, 2011
- Bioinspired Super-antiwetting Interfaces with Special Liquid−Solid AdhesionAccounts of Chemical Research, 2009
- Wetting 101°Langmuir, 2009
- Superhydrophobic surfaces: from structural control to functional applicationJournal of Materials Chemistry, 2007
- Progess in superhydrophobic surface developmentSoft Matter, 2007
- Wetting on Hydrophobic Rough Surfaces: To Be Heterogeneous or Not To Be?Langmuir, 2003
- Super‐Hydrophobic Surfaces: From Natural to ArtificialAdvanced Materials, 2002
- Light-Driven Motion of Liquids on a Photoresponsive SurfaceScience, 2000