Influence of Molecular Aggregation on Electron Transfer at the Perylene Diimide/Indium-Tin Oxide Interface
- 30 November 2016
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 8 (49) , 34089-34097
Abstract
Chemisorption of an organic monolayer to tune the surface properties of a transparent conductive oxide (TCO) electrode can improve the performance of organic electronic devices that rely on efficient charge transfer between an organic active layer and a TCO contact. Here, a series of perylene diimides (PDIs) was synthesized and used to study relationships between monolayer structure/properties and electron transfer kinetics at PDI-modified indium-tin oxide (ITO) electrodes. In these PDI molecules, one of the imide substituents is a benzene ring bearing a phosphonic acid (PA) and the other is a bulky aryl group that is twisted out of the plane of the PDI core. The size of the bulky aryl group and the substitution of the benzene ring bearing the PA were both varied, which altered the extent of aggregation when these molecules were absorbed as monolayer films (MLs) on ITO, as revealed by both attenuated total reflectance (ATR) and total internal reflection fluorescence spectra. Polarized ATR measurements indicate that, in these MLs, the long axis of the PDI core is tilted at an angle of 33–42° relative to the surface normal; the tilt angle increased as the degree of bulky substitution increased. Rate constants for electron transfer (ks,opt) between these redox-active modifiers and ITO were determined by potential-modulated ATR spectroscopy. As the degree of PDI aggregation was reduced, ks,opt declined, which is attributed to a reduction in the lateral electron self-exchange rate between adsorbed PDI molecules, as well as the heterogeneous conductivity of the ITO electrode surface. Photoelectrochemical measurements using a dissolved aluminum phthalocyanine as an electron donor showed that ITO modified with any of these PDIs is a more effective electron-collecting electrode than bare ITO.Keywords
Funding Information
- Basic Energy Sciences (DE-SC0001084)
- Office of Naval Research (N00014-14-1-0580, N00014-16-1-2520)
- Division of Materials Research (DMR-1506504)
This publication has 68 references indexed in Scilit:
- “Supersaturated” Self-Assembled Charge-Selective Interfacial Layers for Organic Solar CellsJournal of the American Chemical Society, 2014
- Lead Methylammonium Triiodide Perovskite-Based Solar Cells: An Interfacial Charge-Transfer InvestigationChemSusChem, 2014
- Oxide Contacts in Organic Photovoltaics: Characterization and Control of Near-Surface Composition in Indium−Tin Oxide (ITO) ElectrodesAccounts of Chemical Research, 2009
- Molecular Self‐Assembled Monolayers and Multilayers for Organic and Unconventional Inorganic Thin‐Film Transistor ApplicationsAdvanced Materials, 2009
- Interfacial modification to improve inverted polymer solar cellsJournal of Materials Chemistry, 2008
- Systematic Investigation of Nanoscale Adsorbate Effects at Organic Light-Emitting Diode Interfaces. Interfacial Structure−Charge Injection−Luminance RelationshipsChemistry of Materials, 2006
- Using Self‐Assembling Dipole Molecules to Improve Charge Collection in Molecular Solar CellsAdvanced Functional Materials, 2005
- Advanced Surface Modification of Indium Tin Oxide for Improved Charge Injection in Organic DevicesJournal of the American Chemical Society, 2005
- Using Self‐Assembling Dipole Molecules to Improve Hole Injection in Conjugated PolymersAdvanced Functional Materials, 2004
- Interface modification of ITO thin films: organic photovoltaic cellsThin Solid Films, 2003