A novel bonding technique to bond CTE mismatched devices
Authors:
- W.F. SchmidtWSW.F. Schmidt
- M.H. GordonMGM.H. Gordon
- 23 December 2002
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 05695503,p. 1151-1158
Abstract
Thermal expansion mismatch between electronic devices and their substrates induces stresses in the assembly during bonding and operation. These stresses in extreme cases cause cracking of the electronic device during bonding. For GaAs devices back-side bonded to a high conductivity artificial diamond substrate using Au-Sn solder, analytical and numerical analyses were conducted to determine the bonding stresses in the GaAs die. Bonding experiments were conducted to study the effect of varying cooling rates on die failure. Experimental data demonstrate that only smaller sized dice (1 mm/spl times/1 mm and 2 mm/spl times/2 mm) survived bonding without cracking. This observation was corroborated by analytical and numerical studies which show that the stress induced in the larger dice exceeded the strength of the material. Slow (/spl ap/2/spl deg/C/min) but continuous cooling from the bonding temperature did not improve the survival rate of the dice significantly. A new cooling scheme was developed utilizing the high temperature creep properties of the Au-Sn solder. This cooling scheme incorporates solder layer creep at high temperatures to relieve the stresses in the attached die. Bonding experiments with sizes up to 10 mm/spl times/10 mm and thicknesses down to 4 mils were performed with a 100% survival rate of the dice.Keywords
This publication has 12 references indexed in Scilit:
- Differential thermal expansion in microelectronic systems2003
- A fracture criterion for gallium arsenide wafersEngineering Fracture Mechanics, 1994
- Thermoelectric devices and diamond films for temperature control of high density electronic circuitsAIP Conference Proceedings, 1994
- Temperature Dependence of the Mechanical Properties of GaAs WafersJournal of Electronic Packaging, 1991
- Bonding stress measurements from the degree of polarization of facet emission of AlGaAs superluminescent diodesIEEE Journal of Quantum Electronics, 1991
- Interfacial Stresses in Bimetal ThermostatsJournal of Applied Mechanics, 1989
- Properties of Die Bond Alloys Relating to Thermal FatigueIEEE Transactions on Components, Hybrids, and Manufacturing Technology, 1979
- Thermal Stress in Bonded JointsIBM Journal of Research and Development, 1979
- INTERLAMINAR THERMOELASTIC STRESSES IN LAYERED BEAMSJournal of Thermal Stresses, 1978
- Analysis of Bi-Metal ThermostatsJournal of the Optical Society of America, 1925