Effect of Layer Thickness on the Physical and Mechanical Properties of Sand Powder 3D Printing Specimens
Open Access
- 19 November 2021
- journal article
- research article
- Published by Frontiers Media SA in Frontiers in Earth Science
- Vol. 9
Abstract
The application of sand powder three-dimensional (3D) printing technology in the field of rock mechanics and mining engineering has tremendous potential, but it is still in the preliminary exploration stage. This study investigated the effect of printing layer thickness on the physical and mechanical properties of rock-like specimens with sand powder 3D printing. Quartz sand powder was used as the printing material, and the specimens were prepared with three different layer thicknesses of 0.2, 0.3, and 0.4 mm. Uniaxial compression tests with a combination of digital image correlation (DIC), acoustic emission (AE) and 3D microscope observations were performed to analyze the mechanical properties and failure patterns of the specimens during loading. Experimental findings showed that increasing the layer thickness from 0.2 to 0.4 mm would result in a decrease in the weight, density, uniaxial compression strength, and elastic modulus of the specimens. The stress-strain curve, deformation and failure patterns, crack growth process, and AE characteristics of the specimens with a layer thickness of 0.2 mm are similar to the AE characteristics of rock-like material, whereas the specimens with layer thicknesses of 0.3 and 0.4 mm deform like a ductile material, which is not appropriate for simulation of coal or rock mass. In future studies, rock-like specimens should be prepared with a small layer thickness.Keywords
This publication has 22 references indexed in Scilit:
- Visual representation and characterization of three-dimensional hydrofracturing cracks within heterogeneous rock through 3D printing and transparent modelsInternational Journal of Coal Science & Technology, 2016
- Fracture Mechanical Behavior of Sandstone Subjected to High-Temperature Treatment and Its Acoustic Emission Characteristics Under Uniaxial Compression ConditionsRock Mechanics and Rock Engineering, 2016
- Reverse modelling of natural rock joints using 3D scanning and 3D printingComputers and Geotechnics, 2016
- Fundamental Study on Applicability of Powder-Based 3D Printer for Physical Modeling in Rock MechanicsRock Mechanics and Rock Engineering, 2016
- Modeling rock specimens through 3D printing: Tentative experiments and prospectsActa Mechanica Sinica, 2015
- Effect of layer printing delay on mechanical properties and dimensional accuracy of 3D printed porous prototypes in bone tissue engineeringCeramics International, 2015
- A Preliminary Study of 3D Printing on Rock MechanicsRock Mechanics and Rock Engineering, 2014
- Experimental study on damage evolution of rock under uniform and concentrated loading conditions using digital image correlationFatigue & Fracture of Engineering Materials & Structures, 2013
- Effects of layer thickness and binder saturation level parameters on 3D printing processThe International Journal of Advanced Manufacturing Technology, 2010
- Effect of particle size on three dimensional printed mesh structuresPowder Technology, 2009