Economically alloyed high-strength steel for use in mine equipment
- 1 October 2016
- journal article
- Published by Allerton Press in Steel in Translation
- Vol. 46 (10) , 742-751
Abstract
The development of low-temperature, high-strength weldable steels for very heavy-duty mine vehicles and pit props is considered. Steels of strength classes S70/60 (σy ≥ 590 N/mm2) and S80/70 (σy ≥ 690 N/mm2) are based on alloying with Cr, Mn, and Si, without added Ni and Mo; wear-resistant steels of strength class S100 (σy ≥ 950 N/mm2) are based on alloying with Cr, Mn, and B, with a small content of Ni and Mo. The bainitic–martensitic or martensitic structure with small lath size obtained after quenching and tempering ensures strength, plasticity, and low-temperature strength of the steels. Microalloying reduces the austenite grain size in recrystallizing rolling (microalloying with V) and in heating of the steel before quenching (microalloying with V and Nb) and also ensures precipitation hardening on account of the precipitation of vanadium- and niobium-carbonitride nanoparticles. The new steels may be used to replace imports of high-strength weldable steels of the same strength classes.Keywords
This publication has 6 references indexed in Scilit:
- Strengthening and Toughening Mechanisms in Martensitic SteelAdvanced Materials Research, 2014
- Tempering of Direct Quenched Low-Alloy Ultra-High-Strength Steel, Part I – MicrostructureAdvanced Materials Research, 2014
- Assimilation of Production of High-Strength Wear-Resistant Weldable Steel with Yield Strength of more than 950 N/mm2 for Supporting Metal StructuresMetallurgist, 2014
- Improving the wear resistance of structural steels through the use of metallurgical production factorsMetallurgist, 2010
- Martensitic Structural Steels for Increased Strength and Wear ResistanceMaterials Science Forum, 2007
- Development and Production of Weldable High-Strength Steels with a Yield Point in the Range from 600 to 950 N/mm2Metallurgist, 2005