Simple measurements of rolling friction and deformation when μ r < 0.001
Author:
- 8 September 2015
- journal article
- Published by IOP Publishing in European Journal of Physics
- Vol. 36 (6)
Abstract
A simple method is described to measure the coefficient of rolling friction, , for a hard ball rolling on a hard, horizontal surface. The method involves attaching a small mass to the side of the ball so that the ball precesses slowly along a spiral path. Since the radius of curvature decreases slowly with time, the decrease in ball speed can be measured over a relatively long path length on a small area surface. Results are presented for three steel bearing balls and a billiard ball rolling on a polished granite surface, with ranging from 0.000 086 to 0.000 84. Estimates of the combined deformation of the ball and the surface are also presented, based on impact duration measurements at very low impact forces.Keywords
This publication has 14 references indexed in Scilit:
- Rolling friction—models and experiment. An undergraduate student projectEuropean Journal of Physics, 2014
- Micro-slippage effects in pre-rolling induced by a disturbed and undisturbed pendulum with spherical supportsProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2013
- A classroom experiment to measure the speed-dependent coefficient of rolling frictionAmerican Journal of Physics, 2007
- The trajectory of a ball in lawn bowlsAmerican Journal of Physics, 1998
- Cyclotron analog applied to the measurement of rolling frictionAmerican Journal of Physics, 1995
- Central drift of freely moving balls on rotating disks: A new method to measure coefficients of rolling frictionAmerican Journal of Physics, 1987
- Introduction to the study of rolling frictionAmerican Journal of Physics, 1987
- Rolling PrecessionAmerican Journal of Physics, 1965
- The Motion of a Biased Bowl with Perturbing Projection ConditionsMathematical Proceedings of the Cambridge Philosophical Society, 1961
- THE DYNAMICS OF A BOWLQuarterly Journal of Mechanics and Applied Mathematics, 1958