Gas hold‐up behavior of mechanically agitated gas‐liquid reactors using pitched blade downflow turbines
- 1 April 1993
- journal article
- research article
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 71 (2) , 226-237
Abstract
Fractional gas holdup was measured in 0.57, 1.0, and 1.5 m i.d. vessels. Pitched blade downflow turbines (PTD) were used as the impeller. Design details of the impeller, such as the impeller diameter (0.22 T to 0.5 T) and blade width (0.25 D to 0.4 D), were studied. The effect of sparger type, geometry and size on fractional gas hold‐up has been investigated in detail. Four different types of spargers (pipe, conical, ring and concentric ring spargers) were used. Sparger location was varied for all the types studied. Further, design details of the ring sparger, which gave the highest hold‐up were then studied in detail. These included ring diameter, number of holes and hole size. All the reported correlations for fractional gas hold‐up in mechanically agitated gas‐liquid reactors were tested and compared. A better correlation has been developed for pitched blade turbines.Keywords
This publication has 15 references indexed in Scilit:
- Role of sparger design on gas dispersion in mechanically agitated gas‐liquid contactorsThe Canadian Journal of Chemical Engineering, 1993
- Effect of addition of alcohol on the design parameters of mechanically agitated three-phase reactorsThe Chemical Engineering Journal, 1992
- FLOW GENERATED BY PITCHED BLADE TURBINES I: MEASUREMENTS USING LASER DOPPLER ANEMOMETERChemical Engineering Communications, 1989
- Gas Holdup and Bubble Diameters in Pressurized Gas-Liquid Stirred VesselsIndustrial & Engineering Chemistry Fundamentals, 1980
- Gas holdup and aerated power consumption in mechanically stirred tanksThe Canadian Journal of Chemical Engineering, 1979
- Some hydrodynamics and power input data in mechanically agitated gas‐liquid contactorsAIChE Journal, 1977
- Stirred‐tank mechanical power requirement and gas holdup in aerated aqueous phasesAIChE Journal, 1977
- Scale‐up of agitated vessels gas‐liquid mass transferAIChE Journal, 1974
- Holdup and flooding in air liquid mixingThe Canadian Journal of Chemical Engineering, 1968
- Bubble size distribution in the impeller region of a stirred vesselChemical Engineering Science, 1967