Study on the Application of Modified Sn-Based Solder in Cable Intermediate Joints
Open Access
- 25 November 2022
- Vol. 15 (23) , 8385
Abstract
With the increasing use of underground cables, the quantity and quality of intermediate joints demanded are also increasing. The quality of the traditional crimping intermediate joint is easily affected by the actual process of the operator, which may lead to the heating of the crimping part of the wire core, affecting the insulation performance of the cable, and finally causing the joint to break. However, aluminothermic reactive technology has some problems, such as a high welding temperature and an uncontrollable reaction. In order to solve these problems, according to the brazing principle and microalloying method, the optimal content of In in Sn-1.5Cu-based solder was explored, and then the connection of the middle joint of a 10 kV cable was completed using a connecting die and electrical connection process. The contact resistance and tensile strength of the joint were tested to verify the feasibility of this method. The results show that the maximum conductivity of the solder with 3.8% and 5% In content can reach 3.236 × 106 S/m, and the highest wettability is 93.6%. Finally, the minimum contact resistance of the intermediate joint is 7.05 μΩ, which is 43% lower than that of the aluminothermic welded joint, and the tensile strength is close to that of the welded joint, with a maximum of 7174 N.Keywords
This publication has 23 references indexed in Scilit:
- Musical Tone Law Method for the Structural Damage DetectionAdvances in Materials Science and Engineering, 2017
- The Coupling Fields Characteristics of Cable Joints and Application in the Evaluation of Crimping Process DefectsEnergies, 2016
- Robust effects of Bi doping on microstructure development and mechanical properties of hypoeutectic Sn–6.5Zn solder alloyJournal of Materials Science: Materials in Electronics, 2015
- A review: On the development of low melting temperature Pb-free soldersMicroelectronics Reliability, 2014
- Study of cable crimping factors affecting contact resistance of medium voltage cable ferrule and lug2013
- Recent advances on Sn–Cu solders with alloying elements: reviewJournal of Materials Science: Materials in Electronics, 2011
- Impurity and alloying effects on interfacial reaction layers in Pb-free solderingMaterials Science and Engineering: R: Reports, 2010
- Investigations of interfacial reactions of Sn–Zn based and Sn–Ag–Cu lead-free solder alloys as replacement for Sn–Pb solderJournal of Alloys and Compounds, 2005
- Interfacial reactions between lead-free solders and common base materialsMaterials Science and Engineering: R: Reports, 2005
- Lead-free Solders in MicroelectronicsMaterials Science and Engineering: R: Reports, 2000