Effect of Single Bevel Groove Geometry on the Impact Strength of Dissimilar Welded Joint of P22 and P91 Steel
Open Access
- 19 September 2022
- journal article
- research article
- Published by MDPI AG in Sustainability
- Vol. 14 (18) , 11739
Abstract
The dissimilar combination of 2.25Cr-1Mo (P22) and modified 9Cr-1Mo (P91) obtained using Gas Tungsten Arc Welding (GTAW) process employing the Ni-based superalloy filler ERNiCr-3 (IN82) and ERNiCrMo-3 (IN625) have been investigated for microstructure evolution and mechanical properties. The butt weld joint was produced using single bevel groove geometry. The structural integrity of the welded joint was measured in respect of tensile strength, impact toughness and hardness. The alloying elements’ segregation at the inter-dendritic areas of the weld metal was witnessed while using the IN82 and IN625 filler. The impact test trials showed the mixed mode of fracture with an impact toughness of 82 ± 6 J and 70 ± 5 J for IN82 and IN625 filler, respectively, ensuring that the welded joint was safe for the end boiler application. The tensile test coupons were fractured from the P22 base metal in all the trials and for both the fillers which confirmed the negligible effect of the filler composition on the tensile properties. The hardness plots showed the inhomogeneity in hardness value, which was also supported by the microstructure evolution along the weldments. The average hardness of the IN82 filler was measured lower than the IN625 filler.Keywords
This publication has 25 references indexed in Scilit:
- Study of Dissimilar Header Welding Between 2.25Cr–1Mo Steel and 9Cr–1Mo Steel with 9018 B9 Electrode Under Various Conditions of Post Weld Heat TreatmentTransactions of the Indian Institute of Metals, 2017
- The fossil fuel power plants technology2017
- Progress in Creep-Resistant Steels for High Efficiency Coal-Fired Power PlantsJournal of Pressure Vessel Technology, 2016
- Residual stress distributions in a P91 steel-pipe girth weld before and after post weld heat treatmentMaterials Science and Engineering: A, 2012
- Characterization of microstructures and mechanical properties of Inconel 617/310 stainless steel dissimilar weldsMaterials Characterization, 2011
- New martensitic steels for fossil power plant: Creep resistancePhysics of Metals and Metallography, 2010
- Boiler Materials for Ultra-Supercritical Coal Power Plants—Steamside OxidationJournal of Materials Engineering and Performance, 2006
- Recent advances in creep-resistant steels for power plant applicationsSādhanā, 2003
- Systematic study of formation of soft and hard zones in the dissimilar weldments of Cr–Mo steelsJournal of Nuclear Materials, 2002
- Materials for Ultrasupercritical Coal Power Plants - Boiler Materials: Part 1Journal of Materials Engineering and Performance, 2001