Silicone‐rubber‐based tactile sensors for the measurement of normal and tangential components of the contact force
- 11 August 2011
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 122 (6) , 3757-3769
Abstract
This article presents the developmental process of a new tactile sensor. The sensor was based on the use of light‐emitting diode (LED) phototransistor couples and a silicone rubber layer positioned above the optoelectronics devices. The optoelectronic components were organized in a matrix structure. For each couple, the LED illuminated the reflective surface, which coincided with the bottom facet of the deformable layer. Practically, the deformable layer transduced an external force into a displacement variation of its bottom facet through its stiffness. An external force applied to the deformable layer produced local variations of the bottom surface of the elastic material, and the couples of optical devices measured the vertical deformations in a discrete number of points. In particular, these vertical displacements produced a variation of the reflected light intensity and, accordingly, of the photocurrent measured by the photodetector. The realized prototype was designed and optimized through finite element analysis. A calibration procedure is also presented, whose results demonstrate the ability of the sensor to reconstruct the contact point and also the normal and tangential components of the contact force. © 2011 Wiley Periodicals, Inc. J Appl Polym Sci, 2011Keywords
This publication has 15 references indexed in Scilit:
- Tactile Sensing—From Humans to HumanoidsIEEE Transactions on Robotics, 2010
- Springer Handbook of Robotics2008
- Low cost thin film based piezoresistive MEMS tactile sensorSensors and Actuators A: Physical, 2007
- A Polymer-Based Flexible Tactile Sensor for Both Normal and Shear Load Detections and Its Application for RoboticsJournal of Microelectromechanical Systems, 2007
- Piezoelectric Vibration-Type Tactile Sensor Using Elasticity and Viscosity Change of StructureIEEE Sensors Journal, 2007
- Design and fabrication of a hybrid silicon three-axial force sensor for biomechanical applicationsSensors and Actuators A: Physical, 2005
- A Tactile Sensor Sheet Using Pressure Conductive Rubber With Electrical-Wires Stitched MethodIEEE Sensors Journal, 2004
- Data glove with a force sensorIEEE Transactions on Instrumentation and Measurement, 2003
- Review Article Tactile sensing for mechatronics—a state of the art surveyMechatronics, 1999
- Automated Tactile SensingThe International Journal of Robotics Research, 1982