Investigation of bending and compression properties on PLA-brass composite using FDM
Authors:
- S.K. SelvamaniSSS.K. Selvamani
- W.K. NguiWNW.K. Ngui
- K. RajanKRK. Rajan
- M. SamykanoMSM. Samykano
- Reji Kumar RRRReji Kumar R
- Avinash M. BadadheABAvinash M. Badadhe
- 27 September 2022
- journal article
- research article
- Published by Elsevier in Physics and Chemistry of the Earth, Parts A/B/C
- Vol. 128
Abstract
No abstract availableKeywords
Funding Information
- Universiti Malaysia Pahang (PDU213226, RDU220334, UIC211506)
This publication has 16 references indexed in Scilit:
- A review of binder jet process parameters; powder, binder, printing and sintering conditionMetal Powder Report, 2020
- Investigation of the parameters used in fused deposition modeling of poly(lactic acid) to optimize 3D printing sessionsInternational Journal of Pharmaceutics, 2019
- Review of materials used in laser-aided additive manufacturing processes to produce metallic productsFrontiers of Mechanical Engineering, 2018
- A general method to improve 3D-printability and inter-layer adhesion in lignin-based compositesApplied Materials Today, 2018
- Polymers for 3D Printing and Customized Additive ManufacturingChemical Reviews, 2017
- Low-Cost Inkjet Printing Technology for the Rapid Prototyping of TransducersSensors, 2017
- The improvement of mechanical and thermal properties of polyamide 12 3D printed parts by fused deposition modellingExpress Polymer Letters, 2017
- Mathematical modeling and FDM process parameters optimization using response surface methodology based on Q-optimal designApplied Mathematical Modelling, 2016
- Post Processing Methods used to Improve Surface Finish of Products which are Manufactured by Additive Manufacturing Technologies: A ReviewJournal of The Institution of Engineers (India): Series C, 2016
- Fracture Surface Analysis of 3D-Printed Tensile Specimens of Novel ABS-Based MaterialsJournal of Failure Analysis and Prevention, 2014