Cultivation of a filamentous mold in a glass pilot‐scale airlift fermentor
Authors:
- 1 April 1981
- journal article
- research article
- Published by Wiley in Biotechnology and Bioengineering
- Vol. 23 (4) , 863-877
Abstract
Results of pilot plant studies using a glass airlift fermentation device (55 liter fermentation volume) have proven the relative merits of such a system in the fermentation of a filamentous mold, Monascus purpureus, on 4% (w/w) starch media. The resultant overall yield of cell mass (Yx/s) of 0.38 was an appreciable increase over the 0.32 obtained with a pilot scale stirred tank fermentor previously studied. Power requirements of the airlift fermentor were approximately 50% of those for the mechanically agitated system. The lack of mechanical shear in the airlift system provides a more gentle environment or the cultivation of organisms than does the high degree of shear prevalent in the mechanically agitated vessels. Mass transfer of oxygen to the aqueous phase of the fermentation volume is improved significantly through use of the airlift device. Mass transfer coefficients in the range of 200 reciprocal hr were obtained to approximately 80 reciprocal hr in the stirred tank fermentor.Keywords
This publication has 13 references indexed in Scilit:
- Effect of interstage mixing in multistage culture systems on continuous biomass productionBiotechnology and Bioengineering, 1979
- Effect of PO2 on growth and physiological characteristics of Candida utilis in a multistage tower fermentorBiotechnology and Bioengineering, 1979
- Bubble flow in the downflow section of an airlift towerBiotechnology and Bioengineering, 1979
- Oxygen‐transfer rates and efficiencies in one‐ and two‐stage airlift towersBiotechnology and Bioengineering, 1979
- Pressure drop, gas hold‐up, and oxygen transfer in tower systemsBiotechnology and Bioengineering, 1977
- Design and performance characteristics of a continuous multistage tower fermentorBiotechnology and Bioengineering, 1976
- Oxygen transfer to mixed cultures in tower systemsBiotechnology and Bioengineering, 1975
- Development and application of the thin channel rectangular air lift mass transfer reactor to fermentation and waste‐water treatment systemsBiotechnology and Bioengineering, 1974
- A continuous, multistage tower fermentor. II. Analysis of reactor performanceBiotechnology and Bioengineering, 1970
- A continuous, multistage tower fermentor. I. Design and performance testsBiotechnology and Bioengineering, 1969