Kinetic Inductance Traveling Wave Amplifier Designs for Practical Microwave Readout Applications
Authors:
Open Access
- 5 April 2024
- journal article
- research article
- Published by Springer Nature in Journal of Low Temperature Physics
- Vol. 215 (3-4) , 152-160
Abstract
A Kinetic Inductance Traveling Wave Amplifier (KIT) utilizes the nonlinear kinetic inductance of superconducting films, particularly niobium titanium nitride (NbTiN), for parametric amplification. These amplifiers achieve remarkable performance in terms of gain, bandwidth, and compression power and frequently approach the quantum limit for noise. However, most KIT demonstrations have been isolated from practical device readout systems. Using a KIT as the first amplifier in the readout chain of an unoptimized microwave SQUID multiplexer coupled to a transition-edge sensor microcalorimeter, we see an initial improvement in the flux noise [1]. One challenge in KIT integration is the considerable microwave pump power required to drive the non-linearity. To address this, we have initiated efforts to reduce the pump power by using thinner NbTiN films and an inverted microstrip transmission line design. In this article, we present the new transmission line design, fabrication procedure, and initial device characterization—including gain and added noise. These devices exhibit over 10 dB of gain with a 3 dB bandwidth of approximately 5.5–7.25 GHz, a maximum practical gain of 12 dB, and typical gain ripple under 4 dB peak to peak. We observe an appreciable impedance mismatch in the NbTiN transmission line, which is likely the source of the majority of the gain ripple. Finally, we perform an initial noise characterization and demonstrate system-added noise of three quanta or less over nearly the entire 3 dB bandwidth.Keywords
All Related Versions
Funding Information
- H2020 Marie Skłodowska-Curie Actions (101027746)
- Italian National Quantum Science and Technology Institut (PE0000023-NQSTI)
- Università degli Studi di Milano - Bicocca
This publication has 21 references indexed in Scilit:
- Readout of a quantum processor with high dynamic range Josephson parametric amplifiersApplied Physics Letters, 2023
- Development of Microwave Kinetic Inductance Detectors for IR Single-Photon CountingJournal of Low Temperature Physics, 2019
- Wide-band parametric amplifier readout and resolution of optical microwave kinetic inductance detectorsApplied Physics Letters, 2019
- Kinetic inductance traveling-wave amplifiers for multiplexed qubit readoutApplied Physics Letters, 2018
- Millimeter-Wave Polarimeters Using Kinetic Inductance Detectors for TolTEC and BeyondJournal of Low Temperature Physics, 2018
- Introduction to parametric amplification of quantum signals with Josephson circuitsComptes Rendus. Physique, 2016
- Multiplexed Readout of MMC Detector Arrays Using Non-hysteretic rf-SQUIDsJournal of Low Temperature Physics, 2013
- A wideband, low-noise superconducting amplifier with high dynamic rangeNature Physics, 2012
- Effect of metal/substrate interfaces on radio-frequency loss in superconducting coplanar waveguidesJournal of Applied Physics, 2010
- Widely tunable parametric amplifier based on a superconducting quantum interference device array resonatorApplied Physics Letters, 2007