Hardness, elasticity, and ultrastructure of bonded sound and caries‐affected primary tooth dentin
Authors:
- 29 August 2006
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research Part B: Applied Biomaterials
- Vol. 81B (1) , 135-141
Abstract
Biomechanical properties of bonded dentin are important factors for resin restoration. We evaluated the hardness and elastic modulus of bonded sound and caries-affected primary tooth dentin using a one-step adhesive system, and observed the microstructure of the bonded interface. Six sound and six carious primary teeth were used. For sound teeth, flat occlusal dentin surfaces were prepared with a water-cooled high-speed diamond bur. For carious teeth, infected dentin was stained with a caries detector and removed with a water-cooled low-speed round steel bur and hand instruments. The prepared dentin was bonded with One-Up Bond F Plus (Tokuyama Dental Co., Tokyo, Japan). The resin–dentin interface and dentin beneath the interface were measured with a nano-indentation tester and observed with SEM and TEM. For both the carious and sound teeth, there was no significant difference between the hardness of the interfacial dentin and dentin 10–80 μm beneath the interface. However, the Young's modulus of the interfacial dentin was significantly lower than the dentin 40–80 μm (carious teeth) or 50–80 μm (sound teeth) beneath the interface. Both the hardness and Young's modulus of the interfacial dentin were not significantly different between the carious and sound teeth. Compared to the sound dentin, the hybrid layer on the caries-affected dentin was thicker and exhibited more complicated morphologic features. The thickness of the hybrid layers was generally less than 1 μm. © 2006 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 2006Keywords
This publication has 18 references indexed in Scilit:
- Comparison of depth of dentin etching and resin infiltration with single-step adhesive systemsJournal of Dentistry, 2005
- Influence of Carisolv on resin adhesion for two different adhesive systems to sound human primary dentin and young permanent dentinJournal of Dentistry, 2005
- A challenge to the conventional wisdom that simultaneous etching and resin infiltration always occurs in self-etch adhesivesBiomaterials, 2005
- The effect of a self‐etching primer on the continuous demineralization of dentinEuropean Journal of Oral Sciences, 2004
- Influence of Carisolv™ for resin adhesion to sound human primary dentin and young permanent dentinJournal of Dentistry, 2001
- Microhardness evaluations of resin-dentin bonding areas by nano-indentation.The Bulletin of Tokyo Dental College, 1999
- Assessment by Nano-indentation of the Hardness and Elasticity of the Resin-Dentin Bonding AreaJournal of Dental Research, 1993
- Comparative SEM and TEM Examination of the Ultrastructure of the Resin-Dentin Interdiffusion ZoneJournal of Dental Research, 1993
- Effect of HEMA on bonding to dentinDental Materials, 1992
- Vibrational Analysis by Raman Spectroscopy of the Interface Between Dental Adhesive Resin and DentinJournal of Dental Research, 1991