Experiments on an Axial Fan Stage: Time-Resolved Analysis of Rotating Instability Modes
- 1 June 2015
- journal article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 137 (6) , 062505
Abstract
Rotating instability (RI) occurs at off-design conditions in axial compressors, predominantly in rotor configurations with large tip clearances. Characteristic spectral signatures with side-by-side peaks below the blade passing frequency (BPF) are typically referred to RI located in the clearance region next to the leading edge (LE). Each peak can be assigned to a dominant circumferential mode. RI is the source of the clearance noise (CN) and an indicator for critical operating conditions. Earlier studies at an annular cascade pointed out that RI modes of different circumferential orders occur stochastically distributed in time and independently from each other, which is contradictory to existing explanations of RI. Purpose of the present study is to verify this generally with regard to axial rotor configurations. Experiments were conducted on a laboratory axial fan stage mainly using unsteady pressure measurements in a sensor ring near the rotor LE. A mode decomposition based on cross spectral matrices was used to analyze the spectral and modal RI patterns upstream of the rotor. Additionally, a time-resolved analysis based on a spatial discrete-Fourier-transform (DFT) was applied to clarify the temporal characteristics of the RI modes and their potential interrelations. The results and a comparison with the previous findings on the annular cascade corroborate a new hypothesis about the basic RI mechanism. This hypothesis implies that instability waves of different wavelengths are generated stochastically in a shear layer resulting from a backflow in the tip clearance region.Keywords
This publication has 15 references indexed in Scilit:
- A Numerical Investigation of Rotating Instability in Steam Turbine Last StageJournal of Turbomachinery, 2012
- In-Duct and Far-Field Mode Detection Techniques2007
- Experimental investigations of rotating flow instabilities in the last stage of a low-pressure model steam turbine during windageProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2005
- An Experimental and Numerical Investigation into the Mechanisms of Rotating InstabilityJournal of Turbomachinery, 2002
- Rotating Instabilities in an Axial Compressor Originating From the Fluctuating Blade Tip VortexJournal of Turbomachinery, 2000
- Experimental Study of Tip Clearance Losses and Noise in Axial Turbomachines and Their ReductionJournal of Turbomachinery, 1997
- ROTATING BLADE FLOW INSTABILITY AS A SOURCE OF NOISE IN AXIAL TURBOMACHINESJournal of Sound and Vibration, 1997
- The effects of tip clearance on the noise of low pressure axial and mixed flow fansJournal of Sound and Vibration, 1986
- A modal separation measurement technique for broadband noise propagating inside circular ductsJournal of Sound and Vibration, 1981
- The measurement of spinning acoustic modes generated in an axial flow fanJournal of Sound and Vibration, 1969