Low loss Sendust powder cores comprised of particles coated by sodium salt insulating layer
Authors:
- 15 April 2015
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 117 (17) , 17A921
Abstract
Toroid-shaped Sendust powder cores were prepared from cold pressing mechanically pulverized Fe-Si-Al powder that had been coated using an inorganic insulating layer. The present work focuses on the effect of the sodium salt-coated Sendust particles upon the high frequency magnetic properties. Sendust powders, having a particle size range of ∼125 μm, exhibit a high saturation magnetization of 118.9 A·m2/kg and a low coercivity of 56 A/m. The experiments indicate that the sodium-based glass insulating layer synthesized from sodium metaphosphate and sodium metaborate can effectively reduce the change in permeability with frequency or DC bias field, yielding high effective permeability (μe) of ∼113 over a wide frequency range from 10 kHz–1 MHz. Furthermore, the effective permeability is measured at ∼27 at H = 7854 A/m, indicating stable and high effective permeability under a DC bias field. The measurements of permeability under DC bias field indicate a peak in the quality factor (Q) values corresponding to a DC-bias field of 1.5–6 (kA/m) at frequencies from 50 to 200 kHz: The effective permeability remains at ∼74. The sodium salt-coated granular cores demonstrate a core loss of 68 mW/cm3 at Bm = 50 mT and f = 50 kHz: These values compare favorably to those of silicone coated Sendust particles.Keywords
This publication has 17 references indexed in Scilit:
- Eddy current and total power loss separation in the iron–phosphate–polyepoxy soft magnetic compositesMaterials & Design (1980-2015), 2009
- Inner demagnetization factor in polymer-bonded soft magnetic compositesJournal of Magnetism and Magnetic Materials, 2008
- Systematic investigation of particle size dependence of magnetic properties in soft magnetic compositesJournal of Magnetism and Magnetic Materials, 2008
- Different annealing treatments for improvement of magnetic and electrical properties of soft magnetic compositesJournal of Magnetism and Magnetic Materials, 2007
- Soft magnetic composite materials (SMCs)Journal of Materials Processing Technology, 2007
- Effect of warm compaction on the magnetic and electrical properties of Fe-based soft magnetic compositesJournal of Magnetism and Magnetic Materials, 2007
- Effect of processing parameters on electrical, mechanical and magnetic properties of iron–resin soft magnetic compositePowder Metallurgy, 2007
- Magnetic properties of polymer bonded soft magnetic particles for various filler fractionsJournal of Applied Physics, 2007
- The correlations between processing parameters and magnetic properties of an iron–resin soft magnetic compositeJournal of Magnetism and Magnetic Materials, 2006
- Theoretical and experimental modelling of composites with oriented soft magnetic particlesJournal of Magnetism and Magnetic Materials, 1996