Material Characterization and Electrochemical Properties of Titanium Alloy 5553 Prepared by Selective Laser Melting as Processed and after Abrading and Polishing
Open Access
- 25 July 2024
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 9 (31) , 34021-34035
Abstract
The microstructure, Vickers microhardness, and electrochemical properties of an additive manufactured titanium alloy, Ti-5553 (Ti-5Al-5Mo-5V-3Cr wt %), are reported on. The alloy specimens were fabricated by selective laser melt processing. The surface morphology and electrochemical properties of the as-processed and surface-pretreated (abraded and polished) Ti-5553 specimens were investigated. The as-processed specimens had a nominal density of 4.62 ± 0.04 g/cm3. Based on comparison with the reported density for the die-cast alloy, the specimens were 99-100% dense with ca. 1% porosity. Optical microscopy and scanning electron microscopy revealed some micropores, balling features, and fusion pore defects across the surface of the alloy (XZ plane-orthogonal to the build direction). The nominal Vickers microhardness was 292 ± 2 HV. Detailed electrochemical characterization of the as-processed and surface-pretreated alloys revealed reproducible open-circuit potentials (OCPs), linear polarization resistances (R p), and potentiodynamic polarization curves for both specimen types in naturally aerated 3.5 wt % NaCl at room temperature. For the surface-pretreated alloys, the OCP was 225 mV more noble, the anodic current in the potentiodynamic polarization curves was 72× lower, the cathodic current was 8× lower, and R p was larger by 426× than the values for the as-processed specimens. The collective electrochemical data revealed that the surface-pretreated alloys exhibit greater corrosion resistance than the as-processed alloys due to a reduction of the real area and the formation of a more passivating oxide layer.Keywords
Funding Information
- Division of Chemistry (CHE-2150173)
- Honeywell Federal Manufacturing and Technologies (DE-NA0002839)
- National Nuclear Security Administration (DE-NA0002839)
This publication has 70 references indexed in Scilit:
- L-PBF der metastabilen β-Titanlegierung Ti-5553: Mikrostruktur und mechanische EigenschaftenBHM Berg- und Hüttenmännische Monatshefte, 2024
- A state of the art on surface morphology of selective laser-melted metallic alloysThe International Journal of Advanced Manufacturing Technology, 2023
- Investigation to Density and Metallurgical Characteristics of Selective Laser Melted Ti-5Al-5 V-5Mo-3Cr Versus Ti-6Al-4 V2023
- Phase transformation of the Ti-5553 titanium alloy subjected to rapid heatingJournal of Materials Science, 2022
- A Review on High‐Strength Titanium Alloys: Microstructure, Strengthening, and PropertiesAdvanced Engineering Materials, 2019
- Printability and microstructural evolution of Ti-5553 alloy fabricated by modulated laser powder bed fusionThe International Journal of Advanced Manufacturing Technology, 2019
- Additive manufacturing technology: the status, applications, and prospectsThe International Journal of Advanced Manufacturing Technology, 2018
- On the Texture Formation of Selective Laser Melted Ti-6Al-4VMetallurgical and Materials Transactions A, 2014
- Microstructures and Mechanical Properties of Ti6Al4V Parts Fabricated by Selective Laser Melting and Electron Beam MeltingJournal of Materials Engineering and Performance, 2013
- Selective Laser MeltingPhotonicsViews, 2012