A Zero Voltage Transition Boost Converter Employing a Soft Switching Auxiliary Circuit With Reduced Conduction Losses
Authors:
- P.K. JainPJP.K. Jain
- G. JoosGJG. Joos
- 30 January 2004
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 19 (1) , 130-139
Abstract
This paper presents a zero-voltage-transition (ZVT) boost converter using a soft switching auxiliary circuit for power factor correction (PFC) applications. The improvement over existing topologies lies in the positioning of the auxiliary circuit capacitors and the subsequent reduction in the resonant current and therefore the conduction losses as compared to other similar topologies. The proposed converter operates in two modes - Mode 1 and Mode 2. It is shown in the paper that the converter should be designed using the constraints obtained in Mode 1 to achieve low-loss switching. The converter is analyzed and characteristic curves presented which are then used in a detailed design example. Experimental results from a 250 W, 127 V input laboratory prototype switching at 100 kHz verify the design process and highlight the advantages of the proposed topology. The proposed converter is suitable for single-phase, two stage power factor correction circuits with universal input voltage range and power levels up to 3 kW.Keywords
This publication has 7 references indexed in Scilit:
- Analysis and design of boost zero-voltage-transition PWM converter2002
- Analysis and design of a zero voltage transition power factor correction circuit2002
- High efficiency telecom rectifier using a novel soft-switched boost-based input current shaper2002
- A novel zero-voltage switched PWM boost converter2002
- A zero-voltage-switched PWM boost converter with an energy feedforward auxiliary circuitIEEE Transactions on Power Electronics, 1999
- A novel active snubber for high-power boost converters1999
- Novel zero-voltage-transition PWM convertersIEEE Transactions on Power Electronics, 1994