Micro-electrode discharge machining: Factors affecting the quality of electrodes produced on the machine through the process of wire electro-discharge machining
Authors:
- 1 March 2007
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 221 (3) , 409-418
Abstract
The introduction of a technique for on-the-machine electrode generation, utilizing wire electro-discharge grinding (WEDG) has broadened the application area of the microelectrode discharge machining (μEDM) process. The present paper studies the capabilities of the WEDG process for manufacturing micro-electrodes. The influence of electrode material, machining strategy, and machine accuracy on the quality of electrodes produced on-the-machine is investigated and a solution is proposed to improve this process. The experimental results reveal the limitations of the WEDG dressing and the effects of electrode material, machining strategy, and machine accuracy on electrode quality, achievable aspect ratio, and surface finish. The study shows that by employing an optical verification system the accuracy of the dressing process could be improved significantly.Keywords
This publication has 6 references indexed in Scilit:
- Study on Factors Determining Limits of Minimum Machinable Size in Micro EDMCIRP Annals, 2005
- Fracture strength analysis of micro WC-shaft manufactured by micro-electro-discharge machiningThe International Journal of Advanced Manufacturing Technology, 2004
- A study on the machining of high-aspect ratio micro-structures using micro-EDMJournal of Materials Processing Technology, 2003
- Typical Metrology of Micro-Hole Arrays Made in Stainless Steel Foils by Two-Stage Micro-EDMCIRP Annals, 1999
- Micro-EDM for Three-Dimensional Cavities - Development of Uniform Wear Method -CIRP Annals, 1998
- Wire Electro-Discharge Grinding for Micro-MachiningCIRP Annals, 1985