Comparative Analysis of Adaptation of Conventional and Printable Complete Denture Bases to the Underlying Casts - An In Vitro Stereomicroscopic Study
Open Access
- 21 October 2024
- journal article
- Published by Medknow in Indian Journal of Dental Research
- Vol. 35 (3) , 315-319
Abstract
Introduction: Properly adapted complete denture bases will have adequate retention to the underlying oral mucosa. With technological advancement, there are various techniques of fabrication of complete dentures. There are studies regarding the marginal adaptation of conventional and CAD-CAM denture bases, but there is not enough research comparing the marginal adaptation and polymerisation shrinkage of conventional and 3D printed complete denture bases. Study Setting and Design: In vitro study using stereomicroscopy to determine the marginal discrepancy between the denture base and the cast. Materials and Methods: Twelve gypsum casts were taken and divided into conventional and 3D-printed groups. Conventional denture bases were fabricated by adapting wax of 2 mm thickness which was subsequently processed whereas 3D printed bases were designed and the standard tessellation language (STL) files were used to print the denture bases. Three points were marked at the mid-palatal line and on both maxillary tuberosities. Digital images were then captured at the marked regions and were used to measure the maximum gap between the cast and denture base at the marked regions. Data were analysed using an independent t-test and one-way ANOVA. Results: Conventional dentures had a significantly lesser marginal discrepancy than 3D printed dentures (P = 0.000). The left maxillary tuberosity showed the highest marginal discrepancy, significantly different from mid-palatal and right tuberosity sites. Conclusion: Conventional dentures perform better than their counterparts in terms of adaptation. This accurate adaptation is vital for the retention of the complete denture.Keywords
This publication has 18 references indexed in Scilit:
- Effects of fabrication techniques on denture base adaptation: An in vitro studyThe Journal of Prosthetic Dentistry, 2020
- CAD-CAM milled versus rapidly prototyped (3D-printed) complete dentures: An in vitro evaluation of truenessThe Journal of Prosthetic Dentistry, 2019
- Modified retention and stability criteria for complete denture wearers: A risk assessment tool for impaired masticatory ability and oral health-related quality of lifeThe Journal of Prosthetic Dentistry, 2018
- Comparison of denture base adaptation between CAD-CAM and conventional fabrication techniquesThe Journal of Prosthetic Dentistry, 2016
- Comparison of treatment outcomes in digital and conventional complete removable dental prosthesis fabrications in a predoctoral settingThe Journal of Prosthetic Dentistry, 2015
- Comparison of the Dimensional Accuracy of Injection‐Molded Denture Base Materials to that of Conventional Pressure‐Pack Acrylic ResinJournal of Prosthodontics, 2004
- Investigation of new complete denture quality and patients' satisfaction with and use of dentures after two yearsJournal of Dentistry, 2004
- A comparison of palatal adaptation in acrylic resin denture bases using conventional and anchored polymerization techniquesJournal of Prosthodontics, 2001
- Comparison of accuracy between compression- and injection-molded complete denturesThe Journal of Prosthetic Dentistry, 1999
- Evaluation of dimensional changes in complete dentures processed by injection-pressing and the pack-and-press techniqueThe Journal of Prosthetic Dentistry, 1983