Preparation and Performance of Porous Polyetherimide/Al2O3 Separator for Enhanced Lithium‐Sulfur Batteries

Authors:

Abstract
As an important component of lithium‐sulfur batteries, the separator has a critical role in battery safety and the corresponding electrochemical performance. In this study, a high‐performance polyetherimide (PEI)/Al2O3 separator was prepared through the non‐solvent‐induced phase separation (NIPS) technique. It was demonstrated that the existence of Al2O3 affects the morphology, thermal stability, electrolyte uptake, ionic conductivity, and electrochemical properties of the PEI/Al2O3 separator. The results indicate that PEI/Al2O3 separators containing 5 and 6 wt % Al2O3 possess high porosity, good electrolyte uptake, excellent thermal stability (thermal shrinkage ratio is only 0.78 % even at a high temperature of 200 °C), and ionic conductivity of practical significance (up to 2.20 mS ⋅ cm−1). Consequently, the assembled cell with the prepared PEI/Al2O3 separator exhibits a better cycling performance (724.9 mA h g−1 after 200 cycles at 0.2 C) than that with the commercial Celgard 2320 separator. Therefore, the PEI/Al2O3 separator prepared by NIPS is a potential separator candidate for high‐safety and high‐performance dischargeable lithium‐sulfur batteries.

This publication has 29 references indexed in Scilit: