A low-power CMOS power amplifier for implanted biomedical ultra wideband (UWB) applications
Authors:
- 1 October 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
Abstract
This paper presents a low power 3.0 to 6.2 GHz wideband power amplifier for implanted biomedical UWB communication system. The UWB PA employs a common-gate (CG) amplifier for wideband input matching, a common-source amplifier with RC shunt-shunt feedback and bondwire inductor source degeneration to obtain the high and flat gain, good linearity and small chip area, and a source-follower for good output matching. The PA was successfully designed with a 0.18μm CMOS technology. The post-layout simulation results indicated that the proposed PA had an average gain of 11dB, an input return loss(S 11 ) less than -14dB, an output return loss (S 22 ) less than -12dB, and an input 1-dB compression point (IP 1dB ) of -14dBm at 4GHz. Moreover, it only consumes a very low power of 13mW at 1.8V supply voltage, and a relatively small chip area of 0.86×0.81 mm 2 .Keywords
This publication has 5 references indexed in Scilit:
- Low Group Delay 3.1–10.6 GHz CMOS Power Amplifier for UWB ApplicationsIEEE Microwave and Wireless Components Letters, 2011
- An Excellent Gain Flatness 3.0–7.0 GHz CMOS PA for UWB ApplicationsIEEE Microwave and Wireless Components Letters, 2010
- Wideband Communication for Implantable and Wearable SystemsIEEE Transactions on Microwave Theory and Techniques, 2009
- A 6-10-GHz CMOS Power Amplifier with an Inter-stage Wideband Impedance Transformer For UWB Transmitters2008
- An ultra-wideband CMOS low noise amplifier for 3-5-GHz UWB systemIEEE Journal of Solid-State Circuits, 2005