Effect of Aluminum Titanate (Al2TiO5) Doping on the Mechanical Performance of Solid Oxide Fuel Cell Ni‐YSZ Anode
- 9 October 2017
- journal article
- research article
- Published by Wiley in Fuel Cells
- Vol. 17 (6) , 862-868
Abstract
The mechanical behavior of un‐doped and 1–10 wt.% aluminum titanate doped NiO‐YSZ anodes was evaluated in the oxidized and reduced state of the material. Sample bars 25 × 5 × 2 mm were fabricated and tested in a three‐point bending apparatus and statistical analyzes of the collected data were performed. A remarkable enhancement of the flexural strength was found both for the reduced and oxidized state of the material when compared to the un‐doped samples. In both cases, the development of a secondary phase was observed proportional to the doping amount of aluminum titanate. Morphological analysis along with preliminary phase identification and suspected mechanisms for strength enhancement are presented and discussed.Keywords
Funding Information
- U.S. Department of Energy (DEFE0026192)
This publication has 53 references indexed in Scilit:
- Influence of microstructure on nano-mechanical properties of single planar solid oxide fuel cell in pre- and post-reduced conditionsMaterials & Design (1980-2015), 2014
- Study of contact resistance at the electrode–interconnect interfaces in planar type Solid Oxide Fuel CellsJournal of Power Sources, 2013
- Alumina Doped Ni/YSZ Anode Materials for Solid Oxide Fuel CellsFuel Cells, 2009
- Mechanical properties of NiO/Ni–YSZ composites depending on temperature, porosity and redox cyclingJournal of the European Ceramic Society, 2009
- Improvement of anode-supported solid oxide fuel cellsSolid State Ionics, 2008
- Dependence of polarization in anode-supported solid oxide fuel cells on various cell parametersJournal of Power Sources, 2005
- Evaluation of Ni and Ti-doped Y2O3 stabilized ZrO2 cermet as an anode in high-temperature solid oxide fuel cellsSolid State Ionics, 2003
- Development of a multilayer anode for solid oxide fuel cellsSolid State Ionics, 2002
- Optimized SOFC electrode microstructureSolid State Ionics, 1996
- Effects of Anode Material and Fuel on Anodic Reaction of Solid Oxide Fuel CellsJournal of the Electrochemical Society, 1992