Fabrication of Anodic Aluminum Oxide Template and Copper Nanowire Surface Fastener
- 19 September 2014
- journal article
- research article
- Published by ASME International in Journal of Electronic Packaging
- Vol. 136 (4) , 044501
Abstract
Through-hole anodic aluminum oxide (AAO) was fabricated by two steps anodization method. The pore diameter of the AAO was 40 nm. Cu nanowire array was prepared using the fabricated AAO as a template by electrochemical deposition. The mechanical and electrical performances of Cu nanowire surface fastener (NSF) were realized by the interconnection of Cu nanowire arrays. The shear and normal bonding strengths for the Cu NSF with 40 nm diameter nanowires were 3.38 × 10−3 and 2.46 × 10−3 N/cm2, respectively, and the parasitic resistance of it was approximately 22.5 Ω · cm2.Keywords
This publication has 9 references indexed in Scilit:
- Growth and properties of gold and nickel nanorods in thin film aluminaNanotechnology, 2006
- Fast fabrication of long-range ordered porous alumina membranes by hard anodizationNature Materials, 2006
- Synthesis of Crystalline Carbon Nanotube Arrays on Anodic Aluminum Oxide Using Catalyst Reduction with Low Pressure Thermal Chemical Vapor DepositionJapanese Journal of Applied Physics, 2006
- Effect of ac Electrodeposition Conditions on the Growth of High Aspect Ratio Copper Nanowires in Porous Aluminum Oxide TemplatesThe Journal of Physical Chemistry B, 2005
- Microtwinning in Template-Synthesized Single-Crystal Metal NanowiresThe Journal of Physical Chemistry B, 2003
- Template Growth of Photoconductive Metal−CdSe−Metal NanowiresThe Journal of Physical Chemistry B, 2002
- Preparation of ordered array of nanoscopic gold rods by template method and its optical propertiesApplied Physics A, 2000
- Preparation of CdS Single‐Crystal Nanowires by Electrochemically Induced DepositionAdvanced Materials, 2000
- Template Synthesis of Nanowires in Porous Polycarbonate Membranes: Electrochemistry and MorphologyThe Journal of Physical Chemistry B, 1997