Fluid overpressure and stress drop in fault zones
Author:
- 1 January 1999
- journal article
- Published by American Geophysical Union (AGU) in Geophysical Research Letters
- Vol. 26 (1) , 115-118
Abstract
Using the average aspect (length/maximum thickness) ratios of 379 mineral‐filled extension (mode I) veins from an active fault zone, the fluid overpressure, during their development, with reference to the minimum compressive principal stress, σ3, is estimated at 20 MPa. Emplacement of such veins increases σ3 and can generate a temporary stress barrier to the propagation of subsequent hydrofractures. On meeting a subhorizontal stress barrier, vertically propagating hydrofractures may change into water sills where the fluid pressure is at or above lithostatic. In this model, stress barriers, and thus water sills, can form at any depth in, and in any type of, fault zones. For such a high fluid pressure, the product of the coefficient of sliding friction and the normal stress in the Modified Griffith Criterion becomes essentially zero and the driving stress associated with faulting equal to twice the in situ tensile strength of the host rock. For typical in situ tensile strengths of 2–3 MPa, the driving stresses for slip on overpressured fault planes is 4–6 MPa. These results are in good agreement with the commonly measured average static stress drops of 3–6 MPa during earthquakes.Keywords
This publication has 21 references indexed in Scilit:
- Introduction to Special Section: Mechanical Involvement of Fluids in FaultingJournal of Geophysical Research, 1995
- On the structure and formation of fracture zonesTerra Nova, 1993
- Model for episodic flow of high-pressure water in fault zones before earthquakesGeology, 1993
- Models of quartz overgrowth and vein formation: Deformation and episodic fluid flow in an ancient subduction zoneJournal of Geophysical Research, 1992
- An earthquake mechanism based on rapid sealing of faultsNature, 1992
- Friction, overpressure and fault normal compressionGeophysical Research Letters, 1990
- Emplacement of dikes, sills and crustal magma chambers at divergent plate boundariesTectonophysics, 1990
- Effect of tensile stress concentration around magma chambers on intrusion and extrusion frequenciesJournal of Volcanology and Geothermal Research, 1988
- Hydrofracturing stress measurements in the Iceland Research Drilling Project drill hole at Reydarfjordur, IcelandJournal of Geophysical Research, 1982
- An extension of the Griffith theory of fracture to rocksJournal of Geophysical Research, 1960