Research and Optimization of Surface Roughness in Milling of SLM Semi-Finished Parts Manufactured by Using the Different Laser Scanning Speed
Author:
Open Access
Abstract
The paper studies the potential to improve the surface roughness in parts manufactured in the Selective Laser Melting (SLM) process by using additional milling. The studied process was machining of samples made of the AlSi10Mg alloy powder. The simultaneous impacts of the laser scanning speed of the SLM process and the machining parameters of the milling process (such as the feed rate and milling width) on the surface roughness were analyzed. A mathematical model was created as a basis for optimizing the parameters of the studied processes and for selecting the sets of optimum solutions. As a result of the research, surface with low roughness (Ra = 0.14 μm, Rz = 1.1 μm) was obtained after the face milling. The performed milling allowed to reduce more than 20-fold the roughness of the SLM sample surfaces. The feed rate and the cutting width increase resulted in the surface roughness deterioration. Some milled surfaces were damaged by the chip adjoining to the rake face of the cutting tool back tooth.Keywords
This publication has 24 references indexed in Scilit:
- Influence of processing parameters on selective laser melted SiCp/AlSi10Mg composites: Densification, microstructure and mechanical propertiesMaterials Science and Engineering: A, 2019
- Optimization of processing parameters and establishment of a relationship between microstructure and mechanical properties of SLM titanium alloyOptics & Laser Technology, 2019
- The Effects of Selective Laser Melting Process Parameters on Relative Density of the AlSi10Mg Parts and Suitable Procedures of the Archimedes MethodApplied Sciences, 2019
- Influence of Powder Deposition on Powder Bed and Specimen PropertiesMaterials, 2019
- Transient dynamics of powder spattering in laser powder bed fusion additive manufacturing process revealed by in-situ high-speed high-energy x-ray imagingActa Materialia, 2018
- A review of defect modeling in laser material processingAdditive Manufacturing, 2017
- Experimental investigation on selective laser melting of 17-4PH stainless steelOptics & Laser Technology, 2017
- Laser powder-bed fusion additive manufacturing: Physics of complex melt flow and formation mechanisms of pores, spatter, and denudation zonesActa Materialia, 2016
- Analysis of defect generation in Ti–6Al–4V parts made using powder bed fusion additive manufacturing processesAdditive Manufacturing, 2014
- Nanostructural self-organization under selective laser sintering of exothermic powder mixturesApplied Surface Science, 2009