Mode Mixity for Circular Hollow Section X Joints With Weld Toe Cracks
Authors:
- 26 January 2005
- journal article
- Published by ASME International in Journal of Offshore Mechanics and Arctic Engineering
- Vol. 127 (3) , 269-279
Abstract
This paper describes the mode mixity of stress-intensity factors for surface cracks at weld toes located at the saddle point in circular hollow section joints. The remote loading applies a uniform tensile stress at the end of the brace along its axis. The three-dimensional finite element models employ mesh tieing between a topologically continuous, global mesh and a separate, local crack-front mesh. Analyses of a simple plate model that approximates key features of toe cracks at the brace-chord intersection verify the negligible effects of the recommended mesh-tieing scheme on stress intensity factors. The linear-elastic analyses compute the mixed-mode stress intensity factors along the crack front using an interaction-integral approach. The mixed-mode stress intensity factors indicate that the crack front experiences predominantly mode I loading, with near the deepest point on the front . The total crack driving force, described by the integral, reaches a maximum value at the deepest point of the crack for the crack aspect ratio considered here. The mode-mixity angle, , at is compared for a range of practical X-joint configurations and crack-depth ratios. The present study demonstrates that the mode-mixity angle increases with increasing brace-to-chord diameter ratio and decreasing chord radius to wall thickness ratio . Values of the nondimensional stress intensity factors ( and ), however, show an opposite trend, with higher crack driving forces for small and large ratios. The variations in the brace-to-chord wall thickness ratio and the crack depth ratio do not generate significant effects on the mode mixity.
Keywords
This publication has 19 references indexed in Scilit:
- Interaction integral procedures for 3-D curved cracks including surface tractionsEngineering Fracture Mechanics, 2005
- An interaction energy integral method for computation of mixed-mode stress intensity factors along non-planar crack fronts in three dimensionsEngineering Fracture Mechanics, 2002
- Analysis of experimental factors in elastic–plastic small specimen mixed‐mode I‐II fracture mechanical testingFatigue & Fracture of Engineering Materials & Structures, 2001
- Crack modeling in FE analysis of circular tubular jointsEngineering Fracture Mechanics, 1998
- Fatigue crack curvature under the weld toe in an offshore tubular jointInternational Journal of Fatigue, 1998
- Mixed-mode steady-state crack growth in elastic-plastic solidsEngineering Fracture Mechanics, 1998
- SIMPLE MODELS FOR PREDICTING STRESS INTENSITY FACTORS FOR TUBULAR JOINTSFatigue & Fracture of Engineering Materials & Structures, 1991
- Stress intensity factor evaluation from displacements along arbitrary crack tip radial lines for warped surface flawsEngineering Fracture Mechanics, 1989
- Mixed-mode stress intensity factor solutions of a warped surface flaw by three-dimensional finite element analysisEngineering Fracture Mechanics, 1987
- An empirical stress-intensity factor equation for the surface crackEngineering Fracture Mechanics, 1981