Effect of Tempering on Mechanical Properties and Microstructure of a 9% Cr Heat Resistant Steel
- 3 January 2012
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 706-709, 841-846
Abstract
Effect of tempering temperature ranged from 400 to 720°C on mechanical properties and microstructure of a P92-type creep resistant steel was investigated. The hardness value of 400 HB, which was obtained after solution treatment, increased to 430 HB with increasing the tempering temperature to 525°С. Further increase in the tempering temperature resulted in gradual decrease in hardness, which approached a level of about 220 HB after tempering at 720°С. The equiaxed particles of MX-type carbonitrides with a size of about 30 nm were precipitated randomly after tempering under all conditions. At temperatures below 525°C, the tempered martensite lath structure (TMLS) was characterized by a random distribution of fine M3C-type carbides and MX-type carbonitrides. The precipitation of M23C6 was observed after tempering at T ≥ 525°C. At 525°C, the M23C6 carbides appeared as thin films on high-angle boundaries (HAB), while M23C6 particles having almost equiaxed shape and located on various boundaries including low-angle lath boundaries precipitate at higher temperatures.Keywords
This publication has 9 references indexed in Scilit:
- Microstructure evolution in a 3%Co modified P911 heat resistant steel under tempering and creep conditionsMaterials Science and Engineering: A, 2011
- Tempering-induced structural changes in steel 10Kh9K3V1M1FBR and their effect on the mechanical propertiesMetal Science and Heat Treatment, 2010
- New martensitic steels for fossil power plant: Creep resistancePhysics of Metals and Metallography, 2010
- Alloy design of creep resistant 9Cr steel using a dispersion of nano-sized carbonitridesInternational Journal of Pressure Vessels and Piping, 2007
- Tempering Behavior of 9%Cr–1%Mo–0.2%V SteelISIJ International, 2006
- Two-phase Separation of Primary MX Carbonitride during Tempering in Creep Resistant 9Cr1MoVNb SteelISIJ International, 2003
- Creep Properties affected by Morphology of MX in High-Cr Ferritic SteelsISIJ International, 2001
- Advances in Physical Metallurgy and Processing of Steels. Strengthening Mechanisms of Creep Resistant Tempered Martensitic Steel.ISIJ International, 2001
- Modelling precipitation sequences in power plant steels Part 1 – Kinetic theoryMaterials Science and Technology, 1997