Effect of scan strategy on the formation of a pure nickel single-crystal structure using a flat-top laser beam via laser powder bed fusion
Open Access
- 25 April 2023
- journal article
- research article
- Published by Taylor & Francis in Science and Technology of Advanced Materials
- Vol. 24 (1) , 2201380
Abstract
In this study, the role of a scan strategy in the fabrication of a single crystal (SX) structure of face-centered cubic (fcc) pure Ni using a flat-top laser profile by a laser powder bed fusion (LPBF) process was investigated. A flat-top laser with a uniform heat intensity across the beam profile was employed to fabricate the SX structure with a texture parallel to the build direction (║BD). A meander scan strategy with an XY–90° scan rotation was required to achieve the flat-top-derived SX structure. The meander scanning strategy promoted the epitaxial fcc growth along the direction ║BD, leading to the ║BD texture formation. Meanwhile, the XY–90° scan rotation induced the epitaxial growth of fcc phase on the hatch direction (HD)–scan direction (SD) plane in the direction deviated by approximately 45° relative to the SD. This 45° deviation relative to the SD occurred to accommodate the beam movement and the circular beam geometry on the HD – SD plane, resulting in the preferred configurations of ║SD and HD. Thus, this paper reports the importance of meander scanning with a 90° scan-rotation strategy to yield a flat-top-LPBF-derived SX structure with ║BD and ║SD and HD textures. GRAPHICAL ABSTRACTKeywords
Funding Information
- Japan Science and Technology Agency
This publication has 48 references indexed in Scilit:
- Thermophysical properties of Ni-containing single-phase concentrated solid solution alloysMaterials & Design, 2017
- Epitaxy and Microstructure Evolution in Metal Additive ManufacturingAnnual Review of Materials Research, 2016
- Microstructural Control of Additively Manufactured Metallic MaterialsAnnual Review of Materials Research, 2016
- Normalised model-based processing diagrams for additive layer manufacture of engineering alloysActa Materialia, 2016
- Evolution of solidification texture during additive manufacturingScientific Reports, 2015
- Microstructural and texture development in direct laser fabricated IN718Materials Characterization, 2014
- Experimental Approbation of Selective Laser Melting of Powders by the Use of Non-Gaussian Power Density DistributionsPhysics Procedia, 2014
- Selective Laser Sintering/Melting2014
- Characterizing flat-top laser beams using standard beam parametersCanadian Journal of Physics, 2006
- The development of columnar grain and single crystal high temperature materials through directional solidificationMaterials Science and Engineering, 1970