Ultrasonic Assessment of the Influence of Cold Rolling and Recrystallization Annealing on the Elastic Constants in a TWIP Steel
Open Access
Abstract
The evolution of the elastic constants, , and Poisson’s ratio and acoustic birefringence of a Fe-0.5 wt% C-21.5 wt% Mn twinning-induced plasticity (TWIP) steel with reduction by cold rolling and recrystallization annealing was assessed from measurements of the times of flight of ultrasonic waves propagating along the thickness of the rolled plates. As the reduction increased, changes in the elastic constants resulted in a steadily increasing orthotropy, which was clearly shown by Poisson’s ratio and acoustic birefringence. Although optical metallography and hardness measurements showed that partial or full recrystallization is attained after annealing at 600 °C and 700 °C, the ultrasonic measurements revealed that a high level of orthotropy remains.
Keywords
Funding Information
- Dirección de Investigaciones Científicas y Tecnológicas, DICYT, Universidad de Santiago de Chile (051814CO)
This publication has 22 references indexed in Scilit:
- Texture Evolution of a Cold-Rolled Fe-28Mn-0.28C TWIP Steel during RecrystallizationMaterials Science Forum, 2013
- Texture generation and implications in TWIP steelsScripta Materialia, 2012
- Effect of chemical composition on work hardening of Fe—Mn—C TWIP steelsMaterials Science and Technology, 2011
- Correlation Between Microstructure and Texture Development in a Cold-rolled TWIP SteelISIJ International, 2011
- The influence of aluminum on hot deformation behavior and tensile properties of high-Mn TWIP steelsMaterials Science and Engineering: A, 2007
- Correlations between the calculated stacking fault energy and the plasticity mechanisms in Fe–Mn–C alloysMaterials Science and Engineering: A, 2004
- Characterization of Microstructural Changes During Annealing of Cold Worked Austenitic Stainless Steel Using Ultrasonic Velocity Measurements and Correlation with Mechanical PropertiesJournal of Materials Engineering and Performance, 2002
- Acoustic study of texture in polycrystalline brassThe Journal of the Acoustical Society of America, 1999
- Ultrasonic velocity measurements for estimation of grain size in austenitic stainless steelNDT & E International, 1995
- Ultrasonic characterization of the effect of cold work and grain size in copper and 68:32 brass sheetsJournal of Materials Science, 1992