A study of plastic strain and plastic strain rate in machining of steel AISI 1045 using FEM analysis
Authors:
- J.P. DavimJ.P. Davim
- C. MaranhãoCMC. Maranhão
- 1 January 2009
- journal article
- Published by Elsevier in Materials & Design (1980-2015)
- Vol. 30 (1) , 160-165
Abstract
No abstract availableThis publication has 14 references indexed in Scilit:
- Effect of machining parameters and cutting edge geometry on surface integrity of high-speed turned Inconel 718International Journal of Machine Tools and Manufacture, 2008
- Metallurgical study on chips obtained by high speed machining of a Ti–6wt.%Al–4wt.%V alloyMaterials Science and Engineering: A, 2007
- Microstructural characterization of Al-7075-T651 chips and work pieces produced by high-speed machiningMaterials Science and Engineering: A, 2006
- Finite element simulation of high-speed cutting forcesJournal of Materials Processing Technology, 2006
- Heat generation and temperature prediction in metal cutting: A review and implications for high speed machiningInternational Journal of Machine Tools and Manufacture, 2006
- Formation mechanisms of nanostructures in stainless steel during high-strain-rate severe plastic deformationMaterials Science and Engineering: A, 2005
- Machinability of 90MnCrV8 steel during high-speed machiningJournal of Materials Processing Technology, 2005
- Effect of high strain rate on plastic deformation of a low alloy steel subjected to ballistic impactJournal of Materials Processing Technology, 2005
- The plastic deformation behaviour of AISI 4340 alloy steel subjected to high temperature and high strain rate loading conditionsJournal of Materials Processing Technology, 1997
- Plastic deformation of 1020 steel over a wide range of strain rates and temperaturesInternational Journal of Plasticity, 1997