A review of techno-economic models for the retrofitting of conventional pulverised-coal power plants for post-combustion capture (PCC) of CO 2
- 1 January 2013
- journal article
- review article
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 6 (1) , 25-40
Abstract
In this paper, we compare and contrast the four most promising (i.e. commercially viable in the near future) technologies for the post-combustion capture (PCC) of CO2 that can be retrofitted to a conventional pulverised-coal power plant. These are CO2 capture using: (i) chilled ammonia, (ii) alkali-metal carbonates, (iii) membranes and (iv) calcium looping. These four technologies are compared to the benchmark monoethanolamine (MEA) scrubbing process in terms of efficiency penalty and cost indicators. We first review the relevant CO2 capture chemistry and typical process flow schematics, and then discuss energy- and mass-balance considerations. We consider 18 published techno-economic studies on these technologies and highlight the key measures, including net CO2 capture rate, net power output, net plant efficiency, capital costs, cost of electricity and cost of CO2 avoided. Calcium looping technology results in the lowest efficiency penalty (4.6%-points) and cost of PCC (36.3% increase in levelised cost of electricity). In addition, the cost of CO2 avoided by employing calcium looping for PCC can be as low as 29 USD2010 per tCO2. On all three of these criteria, calcium looping performs more than twice as well as the benchmark MEA PCC process.Keywords
This publication has 76 references indexed in Scilit:
- Influence of High-Temperature Steam on the Reactivity of CaO Sorbent for CO2 CaptureEnvironmental Science & Technology, 2011
- A technical and economic assessment of ammonia-based post-combustion CO2 capture at coal-fired power plantsInternational Journal of Greenhouse Gas Control, 2011
- Techno-economic evaluation of cryogenic CO2 capture—A comparison with absorption and membrane technologyInternational Journal of Greenhouse Gas Control, 2011
- Techno‐economic analysis of a 300 MWe coal‐fired power plant retrofitted with post‐combustion CO2 captureAsia-Pacific Journal of Chemical Engineering, 2011
- Techno-Economic Analysis of Postcombustion Processes for the Capture of Carbon Dioxide from Power Plant Flue GasIndustrial & Engineering Chemistry Research, 2010
- Oxyfuel carbonation/calcination cycle for low cost CO2 capture in existing power plantsEnergy Conversion and Management, 2008
- Dry Potassium-Based Sorbents for CO2 CaptureCatalysis Surveys from Asia, 2007
- Cost and performance of fossil fuel power plants with CO2 capture and storageEnergy Policy, 2007
- Techno-economic study of CO2 capture from an existing coal-fired power plant: MEA scrubbing vs. O2/CO2 recycle combustionEnergy Conversion and Management, 2003
- Feasibility of polymer membranes for carbon dioxide recovery from flue gasesEnergy Conversion and Management, 1992