Thermal Cycling Experiments on a I Meter Long Divertor Mock-Up with a Rigid Support Structure
Authors:
- 1 December 1996
- journal article
- research article
- Published by American Nuclear Society in Fusion Technology
- Vol. 30 (3P2A) , 793-797
Abstract
Since the thermal loads causes deformation of the divertor plate, it is one of the critical issues to develop support structures which can suppress the deformation within an allowable tolerance. Slide support structures and rigid support structures have been proposed for the ITER divertor plate design. Advantage of the fully rigid support structure is 1) the thermal deformation can almost fully be suppressed, 2) the fabrication process becomes simpler than the slide support structures. However, stresses/strains of the divertor plate with the rigid support structure are seemed to be much higher than those of the slide support structures. To evaluate the thermal fatigue behavior for the rigid support structure, the authors have developed a 1 m long divertor mock-up and have performed the thermal cycling experiments of the mock-up. The mock-up consists of 36 armor tiles, a soft copper (OFHC-Cu) heat sink, and an OFHC-Cu cooling tube. The armor tiles were made of a unidirectional Carbon Fiber Reinforced Carbo...Keywords
This publication has 4 references indexed in Scilit:
- Experiments on heat transfer of smooth and swirl tubes under one-sided heating conditionsInternational Journal of Heat and Mass Transfer, 1996
- High heat flux experiments of saddle type divertor moduleJournal of Nuclear Materials, 1994
- Thermo-mechanical tests of a CFC divertor mock-upJournal of Nuclear Materials, 1994
- Fatigue: A complex subject—Some simple approximationsExperimental Mechanics, 1965