Influence of Starting Material on Final Device in SiC Power Technologies
Authors:
- 30 March 2025
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Abstract
Assessment of proper material specifications at the substrate level is mandatory for successful high-performances SiC power devices. However, SiC defects must be screened during device fabrication through both by inspection analysis and electrical testing. The study and understanding of killer defects allow for the avoidance of on-field failures. This action must be applied not only for mono SiC material but also for SiC-engineered materials. The correlation between crystallographic defects and 650V MOSFET device failures after reliability testing is presented. Devices that failed the High-Temperature Reverse Bias (HTRB) test were considered. Typical material characteristics can then be correlated with electrical failures.Keywords
This publication has 8 references indexed in Scilit:
- Revisiting stacking fault identification based on the characteristic photoluminescence emission wavelengths of silicon carbide epitaxial wafersMaterials Science in Semiconductor Processing, 2024
- Surface defects in 4H-SiC homoepitaxial layersNanotechnology and Precision Engineering, 2020
- Dislocations Analysis on Implanted (p-Type and n-Type) 4H-SiC Epi-Layer by KOH Molten EtchingMaterials Science Forum, 2020
- 2020 IEEE International Reliability Physics Symposium (IRPS)2020
- Fundamentals of Silicon Carbide Technology2014
- Step flow and polytype transformation in growth of 4H-SiC crystalsJournal of Crystal Growth, 2014
- Technological Breakthroughs in Growth Control of Silicon Carbide for High Power Electronic DevicesJapanese Journal of Applied Physics, 2004
- Microelectronic engineering1995