Ripple cancellation technique applied to a synchronous buck converter to achieve very high bandwidth and very high efficiency envelope amplifier
Authors:
Open Access
- 1 March 2013
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10482334,p. 2064-2069
Abstract
This work presents a single stage converter for a high bandwidth and a high efficiency envelope amplifier. The current ripple cancellation technique is applied to a synchronous buck converter to cancel the output current ripple and to decrease the switching frequency without a reduction in the large signal bandwidth. The converter is modeled and the new design with ripple cancellation circuit is detailed. The advantages of the proposed design are presented and validated experimentally. The transfer function of the output filter of the buck converter with ripple cancellation circuit has been modeled and compared to measurements, showing a good correspondence. Experimental validation is provided at 4MHz of switching frequency for DC and variable output voltage for a sinusoidal and a 64QAM signal. Additional experimental validation of the efficiency improvement is provided, compared to the equivalent design (same bandwidth and output voltage ripple) of the conventional buck converter.Keywords
This publication has 11 references indexed in Scilit:
- Optimal design of envelope amplifier based on linear-assisted buck converter2012
- A Zero-Voltage-Switching Contour-Based Power Amplifier With Minimal Efficiency Degradation Under Back-OffIEEE Transactions on Microwave Theory and Techniques, 2011
- A switched-capacitor power amplifier for EER/polar transmitters2011
- Wideband high efficiency digitally-assisted envelope amplifier with dual switching stages for radio base-station envelope tracking power amplifiers2010
- Multilevel Power Supply for High-Efficiency RF AmplifiersIEEE Transactions on Power Electronics, 2009
- Ripple current cancellation circuit2003
- A 'zero' ripple technique applicable to any DC converter2003
- Coupled inductor boost converter with input and output ripple cancellation2002
- Novel aspects of an application of 'zero'-ripple techniques to basic converter topologies2002
- New Class-E DC-DC converter topologies with constant switching frequencyIEEE Transactions on Industry Applications, 1996