Normalizing Effect of Heat Treatment Processing on 17-4 PH Stainless Steel Manufactured by Powder Bed Fusion
Open Access
Abstract
Laser powder bed fusion (L-PBF)-processed 17-4 PH stainless steel (SS) generally exhibits a non-equilibrium microstructure consisting mostly of columnar δ-ferrite grains and a substantial fraction of retained austenite and martensite, contrary to 17-4 PH SS wrought with a fully martensite structure and coarse grains. Despite the different microstructures of L-PBF and wrought 17-4 PH SS, post-processing is typically performed using the conventional heat treatment method. The insufficient effect of the heat treatment on the L-PBF product produces a δ-ferrite phase in the microstructure. To obtain improved mechanical properties, the addition of a normalizing treatment to the conventional heat treatment after L-PBF in a nitrogen gas environment was investigated. The fully martensitic matrix developed by adding the normalizing treatment contained homogeneous Cu precipitates and exhibited a similar or improved strength and elongation to failure compared to the wrought SS.Keywords
This publication has 36 references indexed in Scilit:
- On the superposition of strengthening mechanisms in dispersion strengthened alloys and metal-matrix nanocomposites: Considerations of stress and energyMetals and Materials International, 2014
- Microstructures and Properties of 17-4 PH Stainless Steel Fabricated by Selective Laser MeltingJournal of Materials Research and Technology, 2012
- Metastable Austenite in 17–4 Precipitation‐Hardening Stainless Steel Produced by Selective Laser MeltingAdvanced Engineering Materials, 2010
- Austenite grain size and the martensite-start temperatureScripta Materialia, 2009
- Study on the Microstructure and Mechanical Properties of 17-4 PH Stainless Steel Depending on Heat Treatment and Aging TimeSolid State Phenomena, 2006
- Stabilisation of retained austenite in laser surface melted tool steelsMaterials Science and Engineering: A, 2004
- The relationship between alloying elements and retained austenite in martensitic stainless steel weldsScripta Materialia, 2000
- Optimised post-weld heat treatment procedures and heat input for welding 17–4PH stainless steelScience and Technology of Welding and Joining, 1999
- Microstructural evolution in a 17-4 PH stainless steel after aging at 400 °CMetallurgical and Materials Transactions A, 1999
- Influence of austenite grain size on γ-ε martensitic transformation temperature in Fe-Mn-Si-Cr alloysScripta Metallurgica et Materialia, 1995