K+ Transport in Perfluorosulfonic Acid Membranes and Its Influence on Membrane Resistance in CO2 Electrolysis
- 6 November 2021
- journal article
- research article
- Published by Wiley in ChemElectroChem
- Vol. 9 (4)
Abstract
In CO2 electroreduction it is common to use cation exchange membranes in combination with high‐molar electrolytes. In a model polymer electrolyte membrane (PEM) water electrolysis setup, which mimics CO2 electrolysis in a mixed (modemix) and in a separate electrolyte mode (modesep), this study investigates how K+‐sulfonate interactions increase membrane resistance dependent on the electrolyte concentration. K+‐based electrolytes (KHCO3, K2SO4) are used instead of ultrapure water in the PEM‐model electrolyzer. At 1.0 M KHCO3, the membrane resistance is increased by 1.7 Ω cm2 (cathode side only) to 4.2 Ω cm2 (modemix), causing a significant voltage increase that needs to be invested for K+ transport over a PFSA membrane. We quantify the underlying ionic interactions to 527–545 mV and observed a further effect, namely a space‐charge limitation expressed by a strongly increased voltage, occurring in the case of K+ overload when lacking hopping centers for cation transport. Beginning at ca. 300 mA/cm2, the current density gets high enough to drive K+ back to the cathode side and low enough to prevent large resistive contributions and K+ overload. Along with thermodynamic considerations and pH‐induced intrinsic operational contributions, the membrane resistance was found to have a significant impact contributing to the total cell voltage Vtotal and proved that current research towards green and scalable CO2 electrolysis is on a promising way towards broad application.Keywords
This publication has 35 references indexed in Scilit:
- New insights into the electrochemical reduction of carbon dioxide on metallic copper surfacesEnergy & Environmental Science, 2012
- Effect of cations (Na+, Ca2+, Fe3+) on the conductivity of a Nafion membraneJournal of Power Sources, 2010
- Fabrication of catalyst-coated membrane by modified decal transfer techniqueElectrochemistry Communications, 2010
- Key counter ion parameters governing polluted nafion membrane propertiesJournal of Polymer Science Part B: Polymer Physics, 2009
- Mass Transport through a Proton Exchange Membrane (Nafion) in Microbial Fuel CellsEnergy & Fuels, 2007
- Structure and Energetics of the Hydronium Hydration ShellsThe Journal of Physical Chemistry A, 2007
- Constant‐Distance Mode Scanning Potentiometry. High Resolution pH Measurements in Three‐DimensionsElectroanalysis, 2007
- Transport and equilibrium properties of Nafion® membranes with H+ and Na+ ionsJournal of Electroanalytical Chemistry, 1998
- Dehydration of protonated Nafion® coatings induced by cation exchange and monitored by quartz crystal microgravimetryJournal of Electroanalytical Chemistry, 1997
- The Effect of Space Charge and Residual Gases on Thermionic Currents in High VacuumPhysical Review B, 1913