Bonding durability of polymer-modified concrete repair overlays under freeze–thaw conditions
- 1 December 2017
- journal article
- Published by Emerald Publishing in Magazine of Concrete Research
- Vol. 69 (24) , 1268-1275
Abstract
One of the main issues associated with the reliability and durability of concrete in cold regions is the effect of freezing and thawing cycles on concrete structures. Polymer-modified concrete (PMC), which consists of Portland cement concrete with a polymer modifier, has advantages of good bonding strength to the substrate concrete, high tensile and flexural strengths, and low shrinkage and permeability. Due to their performance and durability, PMC overlays can be considered as a method of preserving damaged concrete structures. In this research, the durability of PMC overlays bonded to conventional concrete substrates under freeze–thaw cycles was investigated. In total, 25 PMC mix designs for repair overlays were examined. To investigate the effects of the type and amount of polymer and the presence of silica fume, two different types of modifier polymer (based on styrene butadiene rubber (SBR) or acrylic) at different replacement percentages and various amounts of silica fume were considered. For both polymer modifiers, maximum bonding occurred with the addition of 20% polymer by cement weight. The best durability was observed with the addition of 5% silica fume. The SBR-based PMCs showed stronger bonding and better durability than the acrylic-based PMCs.Keywords
This publication has 21 references indexed in Scilit:
- Effect of Styrene Butadiene Copolymer (SBR) admixture on high strength concreteConstruction and Building Materials, 2016
- The use of superabsorbent polymers to reduce cracking of bonded mortar overlaysCement and Concrete Composites, 2014
- The influence of superabsorbent polymers on strength and durability properties of blended cement mortarsCement and Concrete Composites, 2014
- The participation ratios of cement matrix and latex network in latex cement co-matrix strengthAlexandria Engineering Journal, 2014
- Near-to-surface properties affecting bond strength in concrete repairCement and Concrete Composites, 2014
- Influence of polymer type on adhesion performance of a blended cement mortarInternational Journal of Adhesion and Adhesives, 2013
- Estimation of bond strength envelopes for old-to-new concrete interfaces based on a cylinder splitting testConstruction and Building Materials, 2011
- SBR latex modified mortar rheology and mechanical behaviourCement and Concrete Research, 2004
- Polymers in concrete: a vision for the 21st centuryCement and Concrete Composites, 1999
- Dimensional variations, capillary absorption and freeze-thaw resistance of repair mortars admixed with polymersCement and Concrete Research, 1993