Predictions of the Pressure Losses in 2D and 3D Model Pump Diffusers
Authors:
Open Access
- 24 May 1993
- conference paper
- Published by ASME International
Abstract
Two methods of evaluating the loss of mechanical energy in CFD predictions are described. It is shown that the difference between the two methods is a good measure of grid dependence for the prediction of the flows in 2D plane and annular model dump diffusers. The additional loss of mechanical energy due to sector end walls is investigated for 3D plane and annular model dump diffusers over a range of sector widths. The results show a strong dependence on the size of the boundary layer on the sector end walls at the inlet to the pre–diffuser. With no boundary layer on the sector end walls, the measured loss on the central symmetry plane is within 15% of the of the underlying 2D loss for pre–diffuser inlet width to height ratios of greater than 10:1. The deviation from the underlying 2D loss increases with the size of the boundary layer on the sector end walls.Keywords
This publication has 6 references indexed in Scilit:
- Numerical Calculations of the Flow in Annular Combustor Dump Diffuser GeometriesProceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 1989
- The Calculation of the Flow through a Two-dimensional Faired Diffuser1989
- A numerical study of annular dump diffuser flowsComputer Methods in Applied Mechanics and Engineering, 1985
- A CALCULATION PROCEDURE FOR HEAT, MASS AND MOMENTUM TRANSFER IN THREE-DIMENSIONAL PARABOLIC FLOWS1983
- A stable and accurate convective modelling procedure based on quadratic upstream interpolationComputer Methods in Applied Mechanics and Engineering, 1979
- Performance of Annular Combustor-Dump DiffusersJournal of Aircraft, 1977