Does Texturing of UHMWPE Increase Strength and Toughness?: A Pilot Study
Authors:
- Frédéric AddiegoFrédéric Addiego
- Olivier BuchheitOBOlivier Buchheit
- David RuchDRDavid Ruch
- Said AhziSaid Ahzi
- Abdesselam DahounADAbdesselam Dahoun
- 1 August 2011
- journal article
- research article
- Published by Wolters Kluwer Health in Clinical Orthopaedics and Related Research
- Vol. 469 (8) , 2318-2326
Abstract
Induce molecular alignment (texture). Questions/purposes We asked how (1) the microstructure of UHMWPE evolves when subjected to tension and (2) whether the new microstructure (texture) increases strength and toughness. Methods We analyzed microstructure evolution of UHMWPE by small- and wide-angle xray scattering and scanning electron microscopy. We then developed a method to characterize the local strength and toughness of undeformed and textured UHMWPEs by means of nanoscratch tests along and perpendicular to the specimen axis. In three samples we determined the scratch characteristics in terms of deformation mode, coefficient of friction (μ), and viscoelastic recovery (r). Results Before the tensile process, the scratch behavior of UHMWPE was characterized by a μ ranging from 0.64 to 0.68, no cracking, and r ranging from 0.58 to 0.60. Microfibrillar morphologic features resulted from the tensile process. The new microstructure had an increased strength (r = 0.78) and decreased toughness (cracking + μ = 0.77) perpendicular to the fibril axis and decreased strength (r = 0.53) and increased toughness (no cracking + μ = 0.55) parallel to the fibril axis. Conclusions Textured UHMWPE behaves like a fiber composite with high strength and toughness in well-defined directions. However, the effect of crosslinking on these specific properties is unknown and therefore it is important to verify that the properties are retained. If wear resistance of crosslinked-textured UHMWPE is at least as high as that of crosslinked UHMWPE, novel medical devices made of crosslinked-textured UHMWPE could be developed and clinically tested....Keywords
This publication has 26 references indexed in Scilit:
- 2009 Knee Society Presidential Guest Lecture: Polyethylene Wear in Total KneesClinical Orthopaedics and Related Research, 2010
- Effect of microstructure on crazing onset in polyethylene under tensionPolymer Engineering & Science, 2009
- Fatigue crack propagation resistance of virgin and highly crosslinked, thermally treated ultra-high molecular weight polyethyleneBiomaterials, 2006
- Deformation, yielding, fracture and fatigue behavior of conventional and highly cross-linked ultra high molecular weight polyethyleneBiomaterials, 2005
- Processing of ultra‐high molecular weight polyethylene by hot isostatic pressing, and the effect of processing parameters on its microstructurePolymer Engineering & Science, 2004
- TEM analysis of microstructural morphology in ultra high molecular weight polyethyleneScripta Materialia, 2000
- Process‐induced residual stresses in compression molded UHMWPEPolymer Engineering & Science, 1999
- Orientation of plane strain-compressed ultra-high-molecular-weight polyethylenePolymer, 1998
- Plastic deformation of thin films of ultra-high-molecular-weight polyethylenePolymer, 1994
- Development of anisotropy in ultra-high molecular weight polyethylenePolymer, 1990