Dynamic Analysis on Underlay Microstructure for Cu/Low-k Wafer during Wire Bonding
Authors:
- 8 October 2009
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 419-420, 489-492
Abstract
Two major analyses were conducted in this paper. In the first, experimental procedures are accomplished to measure the tensile mechanical properties of ultra thin gold wire (=1mil) before/after electric flame-off (EFO). Characteristics of free air ball (FAB), heat affected zone (HAZ) and as-drawn wire have been carefully investigated by nanoindentation, microhardness and self-design pull test fixture. Secondary, with the obtained experimental material data, a comprehensive finite element model using software ANSYS/LS-DYNA is successfully developed to simulate the wirebonding. Dynamic analysis is performed to evaluate the overall stress distributions on the underlay microstructure of Cu/low-k wafer. Special emphasizes are focused on the Copper via and the intermetal dielectric (IMD)/undoped silica glass (USG) dielectric microstructure.Keywords
This publication has 5 references indexed in Scilit:
- Characteristic of Heat Affected Zone for Ultra Thin Gold Wire/Copper Wire and Advanced Finite Element Wirebonding Model2008
- A study of Cu/Low-k stress-induced voiding at via bottom and its microstructure effectMicroelectronics Reliability, 2006
- Comprehensive Dynamic Analysis of Wirebonding on Cu/Low-K WafersIEEE Transactions on Advanced Packaging, 2006
- Thermosonic wire bonding process simulation and bond pad over active stress analysis2004
- Study of wire bonding looping formation in the electronic packaging process using the three-dimensional finite element methodFinite Elements in Analysis and Design, 2004